Anglo Epoxy Repair Mortar
Unequalled hardness and epoxy bonding power.
Provides fast setting (3-6 hours), granite-hard, permanent repairs to badly cracked and worn concrete or stone floors. For use where conventional mortar or other fillers will loosen or fail.
Anglo Epoxy Repair Mortar is virtually indestructible and ideal for repairs to factory floors, driveways, garage floors, steps indoors or out, sills, and grouting in bolts and railings etc.
• May be feather-edged
• No priming required
• Rock-hard finish
• Can be applied as a 5mm screed (when used with Epoxy Bond)
Usage rate: 5kg covers 0.6m2 at 5mm thickness
Sizes available: 2.5kg, 5kg and 25kg
Anglo Epoxy Repair Mortar achieves full strength at only 5mm thick. For deeper repairs build up in layers not exceeding 50mm (allowing to cure between layers) or use Anglo Epoxy Repair Mortar Deep Fill.
An easily trowelled grey mortar that provides a smooth, impervious surface.
The tensile strength of Anglo Epoxy Repair Mortar is up to five times stronger than normal concrete.
Surfaces should be dry and free of contaminants and loose material. Grease or oil should be removed with Anglo Solvent Free Degreaser and the area thoroughly washed off and allowed to dry.
Each pack contains a granular resinous compound and separate containers of curing agent. There is one small bottle of grey curing agent in the 2.5kg unit, two bottles in the 5kg unit and two large bottles in the 25kg unit. Mix the components on a board with a trowel according to the simple instructions on the pack until a smooth grey mortar is obtained. This is applied firmly onto the area to be repaired and finished with a trowel or float. To prevent drag it is advisable to frequently wipe the blade of the tool with a rag moistened (but not saturated) with white spirit. When using Anglo Epoxy Repair Mortar as a screed rather than a patch
repair material we recommend the use of Anglo Epoxy Bond, a two pack adhesive primer.
The mixed working life is half to one hour depending on temperature. If the product is used past its working life, trowelling will become difficult and adhesion will be reduced.
Curing Time: Three to six hours according to temperature. Curing time will be extended by low temperatures. Temperatures of 10ºC and below will arrest the curing of the product.
Anglo Epoxy Repair Mortar is resistant to spillages of oils, dilute chemicals etc.
When fully cured, detergents or degreasants may be used to clean the surface. Do not steam clean or subject to temperatures in excess of 60ºC. Disclaimer
Please download and carefully read product datasheets before application
|
