Rust-Oleum Tub & Tile Refinishing Kit
Manufacturer: Rust-Oleum DIY
Rust-Oleum Tub & Tile Refinishing Kit is a two-component, epoxy acrylic finish designed for refinishing ceramic tile, porcelain, fibreglass and cast iron bath tubs and sinks. Not for use on galvanized steel or flexible plastics, and on areas exposed to extreme heat.
Rust-Oleum Tub & Tile Refinishing Kit is a two-component, epoxy acrylic finish designed for refinishing ceramic tile, porcelain, fibreglass and cast iron bath tubs and sinks. Not for use on galvanized steel or flexible plastics and on areas exposed to extreme heat such as stovetops, or constant high humidity/water immersion such as toilets, swimming pools, hot tubs, saunas, ponds or kitchen sinks. A test patch is recommended.
Features & Benefits
- Tough, hard protective coating which acts like porcelain and ceramic.
- Smooth glossy appearance.
- Superior adhesion in water immersion (baths and sinks).
- Excellent wear and abrasion resistance.
Notes: One kits provides enough material for a 2-coat application on a standard bathtub. Allow paint to dry for at least 3 days (72 hours) before exposing to water.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Typical Coverage (per coat)||4-6m² per pack|
|Touch Dry||2 hours|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
|Davina on 30/05/2018|
If I wanted to do bathroom tiles toilet and sink will I have to buy two of this product ?
Each pack will cover approximately 4-6m² of area.
|Eric on 16/02/2018|
Can you use this on a vitrious China basin. Thank you
|Cat on 16/02/2018|
Do I need to use a top coat/sealer with this?
No, everything required is included in each pack.
|Nargis on 08/04/2017|
Question: Does this kit come with it's own roller or brush? I have noted reviews where the wrong roller was used and the fibres became too soggy.
The kit is not supplied with a roller, in the TDS (Technical Data Sheet) available to download from the 'DATASHEETS' tab on the product page it recommends using a high quality, short nap roller made for kitchen and bath use. A four-inch wide roller is recommended.
|William hoven on 16/02/2016|
Can you use this product on an acrylic bath?
Acrylic would be classed as a flexible plastic so Rust-Oleum Tub & Tile Refinishing Kit wouldn't be suitable to use on it. You can use it on ceramic tile, porcelain, fibreglass and cast iron bath tubs and sinks. Not for use on galvanized steel or flexible plastics and on areas exposed to extreme heat.
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close