Coo-Var Suregrip Anti-Slip Floor Paint
Coo-Var Suregrip Anti-Slip Floor Paint is a ready-mixed aggregated floor coating which provides a rough anti-slip finish to floors when dry.
- Interior/Exterior use
- Light truck traffic
- Available in 8 colours
- Can even be used as a high grip surface on climbing walls
Coo-Var Suregrip Anti-Slip Floor Paint is a safety coating suitable for indoor and outdoor use where a sure foothold is required due to moisture and other substances.
- Steps and stairways
- Disabled ramps
- Machinery areas
- Car pits
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
|Brenda on 17/02/2018|
Have slopping concrete steps leading up to house what is the best paint to make them look better.
All surfaces should be clean, dry, sound and free from contaminants.
Concrete - power floated, granolithic and smooth surfaces should be roughened first to provide a good "key" for the paint. This can be done mechanically by abrading or blasting, or chemically using Coo-Var Acid Etch. These processes will have the advantage in addition to preparing the surface of also removing dirt and laitance. New concrete must be allowed to cure thoroughly which can take up to 3 months.
Apply a 10% thinned coat of Coo-Var Floor Paint to prime and seal the surface prior to applying Coo-Var Suregrip.
|Ron Hughes on 15/11/2017|
Question: Do you need to use a primer before using coo var outdoor anti slip paint
|Dean French on 26/06/2017|
Question: Please would you tell me what the finish is like on the Coo Var Sure Grip Anti slip paint is - is it satin, semi gloss or something else please?
It is a matt, aggregated finish.
|Azurey on 06/04/2016|
Is the non slip surface very rough. I have a 75' length garden where I throw a ball for my dog to run back and forth to me. Would the non slip be too rough on her paws ? also is it easy to clean and sweep off leaves etc.
It is a coarse anti-slip finish which can make it tough to clean. If you're looking for something less aggressive we would recommend Rust-Oleum Tarmacoat.
|Norma burns on 13/01/2016|
How many coats of Coo-Var Suregrip Anti-Slip Floor Paint should I apply on an exterior surface to give maximum protection?
Bare surfaces should first be cleaned, prepared and primed as follows; Coo-Var Penetrating Wood Primer on wood, Coo-Var Zinc Phosphate Primer on ferrous metals, Coo-Var Floor Paint (thinned 10%) or Coo-Var Alkali Resisting Primer Sealer on concrete. Once suitably primed, apply 2 coats of Coo-Var Suregrip Anti-Slip Floor Paint in the desired colour at 6-10m² per litre/per coat by brush or roller.
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close