Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Preparation
• Fixing

Features & Benefits

• Ideal for landings, walkways, ramps, production areas, platforms
• Corrosion resistant and can be used inside or out
• Maintenance free with excellent impact resistance
• Keeps feet and products dry in constantly wet areas
• Use instead of metal or wood to create mezzanine and raised walkway areas
• Can be trimmed to size on site
• Contrasting coloured edge ramp available – easily connects to any size grating
• Made of fire retardent resin certified to BS476 Part 7 (Class 1)
• Incredible strength, chemical resistance and anti slip properties make these resin gratings ideal for heavily used areas. Loose lay or fix to provide an instant, corrosion resistant, impact resistant floor. Will flex under point loading but recover to original position

Preparation

If you need to cut the GRP product, a good quality abrasive disc, jigsaw or hacksaw can be used. The GRP material is quite tough to cut by hand, so if power tools are not readily available, please ask about our cut to size service. If appearance is critical we recommend the application of a small trial area first.

Fixing

This is either laid into a frame or fixed to an existing gantry etc. Fixing clips also available.

‘M’ and ‘L’ Clips: Set out where you will position each grating clip, a guide would be one in each corner and then every 500mm. Push the clips into the open mesh squares so that the clip sits neatly on the load bar(s) and the clip’s base is sitting close to the bottom of the grating panel.

If you are fixing directly on the existing surface, drill a pilot hole through the clip and into the substrate then fix using the appropriate screw and plug. If you are fixing into a support frame you will need to drill through the frame and then use a bolt fitting and tighten the washer and nut underneath the frame.

‘C’ Clips: Set out where you will position the grating clips, a guide would be one in each corner and then every 500mm. Join the two grating panels together and then slot over the ‘C’ clip and twist in place, simply tightening the bolt and nut.