Wethertex CP80 Clad-Seal Steel and Cladding Coating is a high performance, self priming, exterior quality satin paint for use on a variety of metal & plastic substrates. Developed using advanced Optilife Silicone Technology, it is quick drying, highly water resistant and offers excellent protection against rust for up to 12 years
Wethertex Exterior CP80 Clad-Seal Steel & Cladding Coating is impact resistant and suitable for a wide range of substrates, offering ultimate performance. Suitable for use in urban and light industrial atmospheres with moderate sulphur dioxide pollution.
Application by brush, roller & spray to varying substrates including Plastisol, weathered galvanised steel, PVF2, powder coating, steel, tin, aluminium, copper, zinc, lead & many other surfaces. It is ideal for a wide range of domestic, commercial and industrial applications.
Available in 4200+ RAL, BS & NCS colours.
Quick Links - Click To Jump To Section:
Features & Benefits
- High performance, exterior quality metal paint
- Suitable for use on Plastisol, weathered galvanised steel, PVF2, powder coating, steel, tin, aluminium, copper, zinc, lead & many other surfaces
- Incorporates Optilife Silicone Technology for long term protection and peace of mind
- Self priming
- Satin finish
- Highly water resistant
- Rust Inhibiting Technology
- Higher impact resistance compared to many other water based cladding coatings
- Chemically Resistant
- Choose from 4200+ RAL, BS and NCS colours - With long term colour retention
- Offers excellent protection against rust for up to 12 years
Preparation
- Ensure all surfaces to be painted are clean, dry and free from grease and loose or flaking material that may impair adhesion
- Any faults in the substrate, particularly those that can lead to moisture penetration, must be rectified or can affect the finish quality
- If your substrate has been previously painted, rub down with a fine waterproof abrasive paper and then rinse thoroughly
- Bare substrates should also be abraded in a similar manner to allow improved adhesion
- Please avoid inhaling any sanding dust and always wear a face mask if fine sanding
- Special precautions should be taken during preparation of pre-1960’s paint surfaces over wood and metal as they may contain harmful lead
Primer
- Wethertex CP80 Clad-Seal Steel and Cladding Coating is a self priming product
Application
- Stir the product thoroughly and do not contaminate
- For the best results apply by spray, also can be applied by brush or roller
- Application tool type and quality may influence the finished appearance
- Apply liberally and avoid overspreading
- Not to be applied below 8ºC
- Recommended application 2 coats
- On bare substrates please thin CP80 with 10% clean water
- Under normal conditions will be dry after 1-2 hours, and can add additional coats after 3-4 hours
- Ensure good ventilation during drying and application
- Do not apply externally when rain or other inclement weather is imminent, ensure substrate is dry
Storage
- When stored unopened in a dry place at temperatures above 5ºC, shelf life is 12 months from the date of manufacture
- Once you have completed painting ensure you remove as much product as possible from your application tool
- If you have any left over product, ensure that you close the tin by replacing the lid firmly and securely and store in a safe place
- Protect from frost
- To avoid the risk of spillage, always store and transport in a secure upright position
Tool Cleaning
- All equipment must be washed with clean, cold water after use
- Waste material should not be emptied in the drainage system
- Some local authorities have special facilities for the disposal of leftover paint
- Please do not add any product into drains or watercourses
