Krud Kutter Gloss-Off
Krud Kutter Gloss-Off is a no rinse formula that`s specially deisgned to prepare high gloss and other hard-to-stick-to surfaces for repainting or refinishing. Specially formulated to help new paint and varnish bond to old finishes, or as a wall preparation prior to wallpapering. Krud Kutter Gloss-Off cleans and deglosses without sanding increasing adhesion of paint.
Krud Kutter Gloss-Off is a no rinse formula that's specially deisgned to prepare high gloss and other hard-to-stick-to surfaces for repainting or refinishing. Specially formulated to help new paint and varnish bond to old finishes, or as a wall preparation prior to wallpapering. Krud Kutter Gloss-Off can be used on all painted, varnished and lacquered surfaces and removes dirt, grease, grime, smoke, food stains, heel marks, crayon, old wallpaper paste and wax residue from painted or unpainted wood and metal.
Krud Kutter Gloss-Off cleans and deglosses surfaces without sanding, increasing the adhesion of subsequent paint coats. It can be overcoated after only 10 minutes, do not use on porous surfaces, always test first on surfaces not to be re-finished as it will de-gloss most surfaces.
Always wear suitable personal protective equipment; gloves and eye protection. Do not dilute, use full strength. Saturate a coarse, lint-free cloth and apply to surface in a circular motion. Fold and resaturate cloth frequently. Wipe off with a clean cloth, turning cloth often to avoid smears. When the clean, de-glossed surface is dry to the touch (usually about 10 minutes), new finish can be applied. May be coated over after 10 minutes (clean the surface today, recoat even a week later). Krud Kutter Gloss-Off may mark metal, always test on an inconspicuous area first.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!