Envirograf HW/PS Paint Stripper
Envirograf HW/PS Paint Stripper is for use where existing paint or varnish needs to be removed before applying Envirograf Fire Protection. Non Methylene Chloride, non-caustic, non-flammable and extremely effective. Non-drip formula, minimal evaporation and clings to vertical surfaces so avoiding waste.
Envirograf HW/PS Paint Stripper is for use where existing paint or varnish needs to be removed before applying Envirograf Fire Protection. Non Methylene Chloride, non-caustic, non-flammable and extremely effective.
Features & Benefits
- Non-drip formula
- Minimal evaporation
- Clings to vertical surfaces so avoiding waste
Shake container well before use. Ensure there is adequate ventilation when working. Wear protective gloves. Pour a quantity of Envirograf HW/PS Paint Stripper into a suitable container. Using a suitable brush apply a generous even coat (do not brush out) onto the surface to be stripped. Leave for approximately 30 minutes and apply a second coat if required; areas where there are less than 5 layers of paint or varnish may not require a second coat. Once the stripper has penetrated to the substrate, scrape off leaving surface as clean as possible. Rub down stripped area using a scrubbing brush or stainless steel pad and water. Rinse with water and allow to dry.
1 – 4 square metres per litre depending on type, thickness and number of layers of paint to be stripped.
Please note: A written specification should be obtained from our Technical Department for your project prior to use to ensure this system will be suitable. Contact us by phone on 0113 2455450 or email [email protected], products will NOT be sold without this.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
Any Envirograf products to be used in or for Harrods department store should be authorised with our Technical Team prior to purchase.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Be the first to ask a question about this product!