Jotun Steelmaster 60/120
We no longer stock this product, but can recommend Nullifire S606 Solvent-Based Intumescent Coating as our nearest alternative. Please contact our Technical Team on 0113 2455450 (option 2) or send a message to [email protected] prior to purchase/use for advice on suitability.
Jotun Steelmaster 60/120 is specially designed as passive fire protection for steel constructions. Suitable for structural steel to be exposed to a wide range of corrosive environments up to high as a part of a complete system.
Approvals and certificates
- BS 476 (30, 45, 60 minutes)
- UK Rail track/Network rail approved for Specification RT98
Additional certificates and approvals may be available on request.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Spray
- Touch Dry
- 1 hour
|Maz on 2017-02-18 23:37:18|| |
Question: What is the coverage of 1L please ?
Jotun Steelmaster 60/120 doesn't state a coverage rate as it's coverage will vary widely depending on the level of fire protection required and the steel it is being applied to.
To receive a specification for the product please forward us the following information to [email protected]
- Level of fire protection required (i.e. 30, 60, 90min, etc.)
Alternatively you can just forward us drawings, fabrication/cutting lists and we'll extract the information from them but in that instance we'd need some guidance as to what to allow for i.e. all steels on first floor, etc.