- There are no more items in your cart
- Shipping Calculated at checkout
- Total £0.00
Call 0113 245 5450 for Sales or Technical
Alternatively you can email our sales & support team on [email protected]
Coronavirus Updates - Open and Services as Normal (click for more info)
603 Thermoplastic Lines
We no longer stock this product, but can recommend Ennis-Flint Prismo Flexiline as a great alternative.
Description
We no longer stock this product, but can recommend Ennis-Flint Prismo Flexiline as a great alternative.
603 Thermoplastic Lines are an easy to apply, preformed thermoplastic road and surface marking material. Ideal for fast permanent installation or re-instatement of road markings, car park markings and cycleways.
603 Thermoplastic Lines require only one person and a gas torch to install and are extremely flexible.
Features & Benefits
- The most durable line marking system we offer
- Easy to apply by gas torch
- Can be trafficked within minutes of application.
- Professional, durable, highly visible results
- Easy to apply yourself with basic equipment
- Efficient – minimal waste, buy only what you need
- Practical to use in hard-to-reach spaces
- Anti-Skid & Reflective additives available
- Consistent material colour throughout
Recommended Uses
- Areas requiring demarcation including but not limited to - factory units, car parks, roads, walkways, playgrounds, etc.
- Bare tarmac, asphalt and concrete floor surfaces
- Interior & exterior
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
Product Details
Data sheet
- Touch Dry
- 10 Mins
 Jay Milne on 2019-05-21 11:06:12 | Question:
Can the strips of thermoplastic be cut and if so would scissors do it or is it a stanley knife job? |
Answer:
Thermoplastic lines can be cut very easily prior to applicaton and scissors or a stanley knife would be fine. | |
| jay egan on 2018-02-13 12:13:38 | Question: How long do you need to burn 603thermoplastic line |
Answer: Download the '603 Line PDS' document above, this gives detailed application instructions on pages 1 and 2. | |
| Bill Morris on 2017-05-25 06:12:01 | Question: How long are the rolls? |
Answer: 603 Thermoplastic Lines are supplied in 5 metre rolls in various widths. | |
| S snape on 2017-03-22 09:02:59 | Question: When applying line paint from a roll does the side with the blue film go up or down to ground |
Answer: The markings should be placed in position with the protective plastic film uppermost. The plastic film is then removed and heat is applied with a blow torch when ready to apply. Full application instructions can be found in the product data sheet available to download from the 'DATASHEETS' tab on the product page. | |
| Martin Dudley on 2017-02-01 15:56:55 | Question: Can this product be used on block paviers? if so is any primer needed?
Thank you |
Answer: Yes, as long as the surface is primed first with 605 Thermoplastic Tack Primer. | |