We no longer stock this product, but can recommend Sherwin-Williams Macropoxy L524 as a great alternative.
Sherwin-Williams M535 (previously known as Resistex M535) is a single pack, pitch free, vinyl copolymer resin based underwater coating which provides anticorrosive protection when applied onto blast cleaned steel. It is suitable to be used in situations where coal tar pitch products are excluded on health and safety grounds, or where bleed through of pitch into topcoats is not acceptable.
- Macropoxy L574 Blast Primer
- Macropoxy L425, Macropoxy C425V2
Indefinitely overcoatable by itself or by a wide range of antifouling compositions.
Consult Technical Team for details of specifications.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- For Use On
- Application Method
- Brush, Roller, Spray
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- Brush, Roller, Spray
- 4.7m² per litre
- Touch Dry
- 30 Minutes
- UN Number
|PAUL BROOKES on 2019-02-15 13:55:03|| |
Can this product be applied over rylard coflex VT on the underwater hull of a narrow boat..Does it dry hard and is it oil and chemical resistant..Thank You..
Effectively Sherwin-Williams M535 primary use is over vinyl tar products which Sherwin-Williams no longer manufacture, in this case it should be OK, however M535 is based on strong solvents. As per the nature of the coatings, they remain inertly soft, meaning there is more chance of intercoat leaching, the strong solvents in the M535 could interact with the subsequent coating. We would recommend a trial area be performed to ensure the solvents from the M535 do not soften the Coflex into disadvantage.
|James collins on 2017-12-14 06:59:29|| |
Question: Hi would this product be ok to line a water bower that’s being used for animal water?
Sherwin-Williams M535 is really only used as part of a specification using antifouling paints on the underside of ships. It is not the ideal product for your requirement and would be being used out of context.
Assuming the product has got to be 'taint free' as it is lining a vessel supplying water for animals to drink you would need to use a potable water formulation being Sherwin-Williams Macropoxy P300.