SikaCeram Stone, Porcelain & Large Format Tile Adhesive

We no longer stock this product, but recommend you see the SikaCeram range to choose another product that suits your specific application.

SikaCeram Stone, Porcelain & Large Format Tile Adhesive is a fast setting, thick or thin bed (up to 20mm), water resistant cementitous adhesive specifically designed for bonding stone and porcelain tiles to walls and floors. Ideal for interior fixing of all type of stone and porcelain wall tiles.

SikaCeram Stone, Porcelain & Large Format Tile Adhesive typically sets in 2-3 hours. Designed to accommodate sub floor movement, it includes built-in crack resistance for application onto timber substrates such as plywood, composite board, floorboards, floating floors, etc. or locations where slight surface movement or vibration, is likely.

Benefits

• Suitable for under floor heating
• Water resistant
• Rapid setting
• For thick & thin bed (up to 20mm)
• For interior or exterior use
• Conforms to BS EN 12004 C2FT S1

Areas for Use

• Bonding stone and porcelain tiles to walls and floors.
• Internal/External use.
• Recommended for tiling domestic, communal areas.
• Tiling onto common building substrates including concrete, cement screeds, plaster, masonry, construction boards and old ceramic tiles.
• Particularly suitable for application onto timber substrates (plywood, floorboards etc).

Limitations

• Do not use on natural stones (e.g. travertine, marble etc.) which are sensitive to discolouration.
• Do not apply if ambient temperature is below 5°C or if freezing temperatures forecast over following 24 hours.
• Do not walk on floors for at least 2 hours after application (longer at low temperatures).
• Do not mix more material that can be handled in 30 minutes.
• Do not attempt to re-constitute the mix with water once setting has occurred.
• It is the user’s responsibility to determine suitability for use. If in doubt contact Technical Services for advice.