

We no longer stock this product; please contact our technical team on 0113 2455450 (option 2) or send a message to [email protected] where we will be happy to find an alternative product.
Remmers Joint Grout is used to repair joints in brick and clinker facades in the Remmers Facade Grout System with simultaneous hydrophobization of the facade. It is not suitable for scarred and/or sanded brick, hand-formed brick and brick with a textured surface!
Remmers Joint Grout is a factory mixed, cement bound repair system. The grout is durable, has good frost resistance and is water vapour permeable and abrasion resistant. Does not contain any corrosion promoting substances. Joint Grout grey (Art. No. 0435) is a special grout with high sulphate resistance and a low, active alkali content. Joint grout colour (Art. No. 0437) can be matched on the basis of colour samples.
IMPORTANT It is essential that a trial area at least 1m² is set up to determine whether the colour, look of the joint, strength and/or adhesion to the sides of the joint and reduced water absorption meets requirements. The trial surface is to be documented, e.g. date, material, application rate, weather, temperature, water absorption with a test plate or test tube before/after which serves as a reference surface.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
• These colour samples are to be used for guidance only.
• Product contained within is generic to provide a close representation to your chosen colour.
• Should not be used to carry out any painting project, this is for colour selection purposes only and does not remove the need for you to ensure the correct product is chosen and tested for your application once a colour has been decided on.
• It is not a sample of the product you intend to purchase/use and cannot be used to test anything other than colour appearance.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application, batches variances number of coats and substrate surface.
• We cannot therefore promise that the colour of the product you ultimately purchase will exactly match the colour of this colour sample.
• Once you have selected a colour, you must purchase the smallest amount of the product you intend to use in your chosen colour and apply to a small, inconspicuous test area to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application and product surface.
• We cannot therefore promise that the colour of the product you paint with the Kolorbond paint will exactly match the colour of the item you send to us.
• You must therefore purchase the smallest Kolorbond paint pot available first and then apply the paint to a small, and where possible hidden, test area of your product to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint to your product if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.