Remmers Mould Restoration Render is a capillary active, climate regulating render used to repair, renovate and refurbish damp interior walls in old and new buildings at risk of mould to prevent condensation processes. Because of its low weight per unit area and favourable deformation behaviour, Mould Restoration Render is also suitable for substrates with less strength and less load-bearing capacity.
It can be used on all mineral substrates that are suitable for the application of render such as masonry brick, sand-lime brick, concrete, aerated concrete, rubble stone and lime-cement render (indoors and outdoors). Because of it high capillary conductivity, Remmers Mould Restoration Render accelerates drying of damp surfaces.
Because of its low thermal conductivity coefficient, the light-weight render is thermally insulating. Since the temperature rises on the surface of the interior wall, relative moisture is lower in the layer of air close to the surface which prevents the growth of mould spores in damp areas above the dew point.
The water vapour permeable and water resistant mortar has a high water storing capacity. All of these properties prevent renewed infestation with mould over the long term. Low in chromate in accordance with RL 2003/53/EC.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- 5.8 - 6.8kg per m²/ per cm of thickness
Be the first to ask a question about this product!