- There are no more items in your cart
- Shipping Calculated at checkout
- Sub-Total (ex. VAT) £0.00
We no longer stock this product; we have some recommended alternatives as listed below but due to the specialist nature of these coatings, please contact our technical team prior to purchase/use on 0113 2455450 (option 2) or send a message to [email protected] to confirm suitability for your project.
Jotun Baltoflake is a glass flake reinforced unsaturated polyester coating. It is an ultra high build, extremely abrasion resistant and fast curing barrier coating that can be used as primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, stainless steel, aluminium and approved primers.
Jotun Baltoflake is recommended for areas subject to extreme mechanical wear and harsh exposure conditions. Recommended for offshore environments, including splash zones, jetties, piles, tidal zones, decks, battery rooms, power stations, exterior of buried tanks, concrete bunds, refineries, bridges, mining equipment and general structural steel where future maintenance is chalenging.
Approvals and certificates
- APAS approved to specification 2917, 2917F, 2917P and 2917S
- Norsok M501 / ISO 20340
Additional certificates and approvals may be available on request.
Features & Benefits
- Superior lifetime
- Extreme mechanical strength
- Fast cure
Baltoflake cures so fast that you can walk on it only three hours after application. Perfect for painting in tidal zones where curing time is crucial.
Spray up to 1500 microns in a single coat on a vertical steel surface without sagging.
Baltoflake gives immense strength and protection against water, chemicals, solvents, abrasion or mechanical attack - outperforming traditional protection such as metallizing and epoxy coatings.
Baltoflake is pre-qualified in several NORSOK coating systems (System No. 1 and 7).
IMPORTANT: Jotun additives MUST be bought with this product to ensure drying and correct use. Please refer to the product Technical Data Sheet for information on which additives and how much of each are required. If in doubt, please contact our Technical Department on 0113 2455450.
- Jotun Norpol Accelerator 9802 P (formerly known as Jotun Accelerator CO1P)
- Jotun Peroxide 1
- Jotun Inhibitor 51
- For Use On
- Concrete, Steel
- Application Method
- Standard / Ready Mixed
- VOC Levels
- Low (50-149 g/l)
- Single, Two or Three Pack
- Pack Size
- 0.6 to 1.5m²/l
- Touch Dry
- 2 hours
Be the first to ask a question about this product!