• Jotun Baltoflake Ecolife

Jotun Baltoflake Ecolife


We no longer stock this product; we have some recommended alternatives as listed below but due to the specialist nature of these coatings, please contact our technical team prior to purchase/use on 0113 2455450 (option 2) or send a message to [email protected] to confirm suitability for your project.

Product not available
This Product has been Discontinued


Jotun Baltoflake Ecolife is a one component styrene free glass flake reinforced unsaturated polyester coating. It is an ultra high build, extremely abrasion resistant and fast curing barrier coating that can be used as primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, stainless steel, aluminium and approved primers. It can be applied down to +5°C surface temperature.

Jotun Baltoflake Ecolife is recommended for areas subject to extreme mechanical wear and harsh exposure conditions. Ideal for offshore environments, including splash zones, jetties, piles, tidal zones, decks, battery rooms, power stations, exterior of buried tanks, concrete bunds, refineries, bridges, mining equipment and general structural steel where future maintenance is challenging.

Approvals and Certificates

  • Pre-qualification testing in acordance with NORSOK M-501, Rev. 3/4, System 7, suitable for splash zone.

Additional certificates and approvals may be available on request.

Features & Benefits

  • Superior lifetime
  • Extreme mechanical strength
  • Fast cure and low temperature cure
  • Styrene free

Fast cure

Baltoflake Ecolife cures so fast that you can walk on it only three hours after application. Perfect for painting in tidal zones where curing time is crucial. 

Few coats
Spray up to 1500 microns in a single coat on a vertical steel surface without sagging.

Superior protection

Baltoflake Ecolife gives immense strength and protection against water, chemicals, solvents, abrasion or mechanical attack - outperforming traditional protection such as metallizing and epoxy coatings.

NORSOK pre-qualification

Baltoflake is pre-qualified in several NORSOK coating systems (System No. 1 and 7).

IMPORTANT: Jotun additives MUST be bought with this product to ensure drying and correct use. Please refer to the product Technical Data Sheet for information on which additives and how much of each are required. If in doubt, please contact our Technical Department on 0113 2455450.

Associated Additives

Product Details

Data sheet

For Use On
Steel, Aluminium
Application Method
Brush, Spray
Standard / Ready Mixed
VOC Levels
Ultra-Low (5-49 g/l)
Single, Two or Three Pack
Brush, Spray
0.6 to 1.6m²/l
Touch Dry
2 hours
UN Number

Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.

Be the first to ask a question about this product!

Question about the product

* Required fields