Envirogard Smart Strip Pro Paint Remover (formerly Dumond Smart Strip PRO) Professional Strength Paint Remover effectively removes 2-component, high-performance coatings and lead paints, including multiple coats of oil-based, water-based, acrylics, varnishes, epoxies, urethanes, elastomeric and lead paint from most interior or exterior surfaces (wood, brick, stone, concrete, plaster, metal, most plastic, most glass and fiberglass).
Envirogard Smart Strip Pro Paint Remover (formerly Dumond Smart Strip PRO) Professional Strength Paint Remover effectively removes 2-component, high-performance coatings and lead paint.
Formulated without methylene chloride, is non-carcinogenic, non- caustic, and non-flammable, this water-based paint remover will effectively remove multiple coats of oil-based, water-based, acrylics, varnishes, epoxies, urethanes, elastomeric and lead paint from most interior or exterior surfaces (wood, brick, stone, concrete, plaster, metal, most plastic, most glass and fiberglass).
Envirogard Smart Strip Pro Paint Remover Professional Strength Paint Remover delivers the superior performance professionals are looking for when removing even the most difficult coatings, being user-friendly, biodegradable, low odour, low VOC and does not require neutralization. It can be used with or without the Envirogard Smart Strip Protective Wrap (Formerly Dumond Laminated Paper), however, efficacy is enhanced and the dwell-time is extended when used.
No recommended for use on:
Always perform a small inconspicuous test area on each type of substrate and paint coating prior to full application. Testing before beginning any project is the best way to ensure product effectiveness. Test patches can determine the proper dwell time and thickness to apply the product for your specific application. Failure to do a test patch can result in need for more than one application, increasing labour and material costs.
Before applying to the entire substrate, always do a test patch. Recommended for use on:
Ideal for a wide use of residential, commercial and industrial applications, delivering superior performance demanded on historic restoration and lead abatement projects without damaging the surface being stripped - can also be used to remove flooring adhesives and mastics.
Be sure that the surface is clean, dry and dull before beginning your project.
Protect and cover all areas such as vegetation and other surfaces not designated to be stripped including adjoining surfaces where overspray and rinse water may travel.
Solvent-resistant polyethylene sheets can be used as an effective barrier. Wet down all vegetation before beginning and cover with 6 mil solvent resistant polyethylene sheeting.
Be careful not to lay sheeting on vegetation in the sun or it may result in killing the foliage.
To avoid product from freezing and reducing effectiveness do not use below 35°F (approx. 2℃).
For best results, use product in temperatures above 50°F (approx. 10℃) and below 90°F (approx. 32℃). Product effectiveness is increased in warmer temperatures.
Envorogard always recommends working in smaller manageable areas when stripping unless you are working with many people.
Using a trowel, brush, roller or airless paint sprayer, apply paste no less than a 1/8” according to test patch results. For a 24- hour dwell time ¼ inch is recommended.
When applying onto irregular surfaces use a nylon brush to force paste into intricate areas.
Product can dwell between 3-24 hours if necessary.
Smart Strip PRO Paint Remover provides an average spread rate of approximately 40-50 Sq. Ft. per gallon; results may vary based on substrate texture and porosity.
Envirogard recommends that Smart Strip PRO be sprayed with an airless paint sprayer.
The sprayer pump size should be at least 1 gallon per minute and all gun and manifold filters should be removed prior to spraying. Hose size should be a new 1/4" ID, however a 3/8" ID hose will reduce strain on the sprayer. It is always recommended to use a new hose on the job, as old paint in the lines will dislodge and cause clogs during application.
Keep a clean bucket of water available, as an occasional flush of the pump may be necessary on hot days to alleviate clogs and the pumps inability to build up pressure.
Do not leave Smart Strip PRO in the sprayer or spray lines overnight. Flush the sprayer and hose thoroughly each day and upon completion with warm water and dish detergent.
Once Smart Strip PRO is ready to be removed use a pressure washer or scraper (preferably plastic).
After all paste has been removed, immediately use a nylon brush and clean water to scrub residue off the substrate, paying attention to crevices, grooves and cracks. Rinse thoroughly with water to remove all remaining residue.
For optimal results, low pressure washing is recommended for final rinse when working outside.
Dispose of paper, paste remover and dissolved coatings according to federal, state and local regulations. If you are having difficulty removing the residue after stripping use the Peel Away After Strip and a nylon scrub brush to remove.
If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
Envirogard Smart Strip Pro Paint Remover is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT
Envirogard Smart Strip Protective Wrap (Formerly Dumond Laminated Paper) is one of the most respected and widely used environmentally friendly lead-based paint removal products in the world.Controls lead-dust dispersal on historic restoration and lead remediation projects by adding containment of lead-based paints and hazardous materials...
£54.64 (incl. VAT)
£45.53 (ex. VAT)
