Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application
• Limitations

Features & Benefits

• Consolidating primer - consolidates and protects mineral finishes such as plasters and sandstone
• Reduces substrate absorption
• Increases durability of the solution
• Mineral. Silicate-based
• Highly breathable - Supports air flow eliminating condensation
• Outstanding adherence, resistance and durability
• High penetration. Does not form impermeable layer
• Ecological and free of VOC emissions
• Suitable for use on interior and exterior surfaces
• Colourless finish treatment maintains the original appearance of the surface

Application

• Suitable for exposed mineral substrates such as rendering, plastering, concrete, calcareous sandstone, etc. Also for very absorbent substrates such as mud, clay, adobe, etc.
• The substrate must be dry, firm, well adhered, even and free of any impurities that could hinder the perfect bonding of the product
• Any organic growth and/or other impurities should be removed by thorough cleaning using specific products for this purpose
• If the substrate is not well adhered, remove the non-adherent areas by scraping and brushing
• Dilute 3:1 with water and shake until homogenous
• Apply with roller, brush or airless spray 1 or 2 coats depending on substrate absorption or desired protection. Do not saturate substrate with the product
• Clean tools after use with warm water
• Dries in 24 hours at 25°C and 60% relative humidity

Limitations

• Do not apply under direct sunlight, on surfaces heated by the sun or in anticipation of rain
• Mineral substrates must be at least 28 days old, cured and dry
• The surfaces to be painted must be resistant to high alkalinity
• Do not apply to surfaces with stagnant water or in permanent contact with water
• It is recommended to protect the treated surface from rain and atmospheric humidity for 4 days
• Should there be any strict aesthetic requirements, it is recommended to carry out preliminary tests. Product may cause slight darkening of the finish
• Parts that are not going to be treated should be protected (glassware or carpentry)
• To maintain product efficacy do not mix with other brands