Nu-Cryl WRS Colour Enhancer is specially-designed to enhance and lift the true colour of your building substrate. An excellent application on natural stone as well as concrete and brickwork, and also on more exotic buildings and architecture made of granite, marble and terrazzo.

Why is lifting the colour of your building important?
Many businesses and establishments spend a lot of money on the right aesthetic look of their building, and they want it to last a long time. Seasonal variations, dirt, oil, and everyday use take its toll on brickwork and other building materials. Applying a colour enhancer such as the Nu-Cryl WRS Colour Enhancer preserves the great look of the building, whilst providing on-going protection from the elements & wear and tear.

Although the coating is milky white on application, it dries clear.

Product Use in the Workplace

• Public building - Spending public money on buildings means the finished article has to represent the place and people. It can never be dirty or dull-looking, but without proper maintenance, this outcome is all too possible. And of course it's likely to rain, which can allow organic growth to start forming on the building, adding to the unappealing look.
• Commercial office - The cost of building the perfect commercial outlet can mount up; with the perfect brickwork chosen, it's important to reduce the effects that UV and weathering has on substrates, and to restore and lift the natural colour. The building must have the best appearance it possibly can, with on-going protection against the elements.

Features & Benefits

• High resistant resistance to weathering and UV degradation.
• Conforms to EN 1504-2.
• Enhances the natural colour of the substrate.
• Stain and dirt resistant.
• Water repellent.
• Excellent water repellent qualities, reduces penetration of oil and water
• Prevents against frost damage and organic growth.
• Moisture vapour permeable.
• Non-stick and allows easy chewing gum removal.
• Unaffected by freeze/thaw cycles.

Preparation

Ensure surfaces to be treated are clean, free from contamination and dry. Treat all areas affected by organic growth with Hydron SS1 Sterilising Solution. All equipment should be cleaned with water immediately after use. Store away from direct sunlight and sources of heat and protect from frost.

Application

Application by low pressure spray or by brush/roller taking care to avoid any sagging. Application on vertical surfaces should be to full saturation commencing at the bottom and working upwards. One application is normally required, however, on porous substrates a second application may be required. Apply the second application in the same manner immediately after the first application, taking care not to allow the first application to dry out. Do not apply at temperatures below 5°C. Shake container well before use. The coverage rate is dependent upon the porosity of the substrate, but average coverage rate between 6-16m²/Litre.