Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application

Features & Benefits

• Easy to apply with any type of spraying equipment (aerographic, airmix and airless)
• Good wetting properties, transparency, thixotropic, smoothness, surface hardness, appearance and uniformity of matting
• Good resistance to abrasion, rubbing and scratching
• Good covering power
• The acrylic-aliphatic nature of the product makes the process unalterable to the light action
• Excellent fireproofing contribution to all types of wood supports classified as D-s2,d0. The process classified according UNE-EN 13501-1:2007 + A1:2010 norms, confer classification of B-s2,d0

Application

• Support: All types of veneers and woods, commonly used for coating walls and ceilings. Do not apply on woods containing over 12% of humidity
• Preparation of the support: Remove the residues of sandpapering
• Application: Homogenize the varnish prior to use. Once the varnish is mixed with the hardener, it gets a viscosity of approximately 24” Ford Cup No.4. Depending on the type of application the viscosity can be adjusted to about 18-20”, by adding 5% of a solvent like 125 DPN, S-157, etc
• Mix ratio 10:1 mix with IC212 Catalyst and 5% 43000 Thinner
• Process: To comply the norm UNE-EN 13501-1:2007 + A1:2010, apply 3 coats of 150-170 gr/m2 of the same product. First, leave cure 16-20h (a night), sand lightly with a piece of 320 grit flexible sandpaper, clean by blowing with pressure air and apply the other two coats with an interval of 2-3 hours between them
• It is possible to obtain other gloss levels applying 1 coat of 80-100 gr/m2 of Irufire Top Coat IC123 in the desired gloss degree (catalized at 10% with Irufire Catalyst)

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.