Intumescent Strips - Fire & Smoke Seal Door Kit
Manufacturer: Rawlins Paints
30 minute intumescent strips, which act as fire and smoke seals for fire door assemblies. Will work with any approved fire door to provide a complete intumescent fire protective system. They are graphite based, contained in a PVC sleeve and are self-adhesive tape backed for ease of installation.
Intumescent Strips / Seals for Fire Doors
Don't leave anything to chance, make sure your fire-door passes fire-safety building regulations with approved Astroflame Astrostrip Intumescent Fire & Smoke Seal Door Kit. These intumescent strips will work with any approved fire door to provide a complete intumescent fire protective system. Astroflame Astrostrip Fire & Smoke Seal Door Kit are graphite based, contained in a PVC sleeve and are self-adhesive tape backed for ease of installation.
What You Get
- 2 x 2.1m lengths
- 1 x 1.05m length
- Fitting instructions
Note: All seals are 4mm deep x 10mm wide
Intumescent fire and smoke seals for fire door assemblies - An intumescent graphite based fire seal contained within a PVC sleeve for fitting into a rebate to either the leaves or the frame of a door. In the event of a fire the seal expands (intumesces) to many times its original volume and seals the gap around the door to provide a safe and effective barrier against the passage of fire, smoke and hot gases.
Our Intumescent Fire Seals are supplied with a cold smoke seal in the form of a nylon pile, providing a barrier to smoke - particularly important as smoke fumes travel faster and further than the fire itself. They also have acoustic and thermal applications. All fire and smoke seals are supplied with a selfadhesive backing tape as standard to facilitate quick and easy fitting.
- Tested for 30 minutes with 10mm and 15mm to BS 476 part 22 & 31.1
- Smoke seals tested to EN1634-3
- Tested to 100,000 open/close cycles
- NHBC Type Approval
Please Note: Each fire door will have its own test evidence from the door manufacturer. It is the responsibility of the purchaser to ensure that fire seals are fully compliant with the relevant door test evidence.
For white, coloured or clear varnish solutions to upgrade solid wood/timber doors up to 30 mins' fire resistance see our Door Upgrade Kits.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Susan on 02/03/2017|
Question: Where do you stick these intumescent strips, round the door or round the frame? If you are fire proofing an original door in original frame will the door still close? There are no fitting instructions on your site.
Our intumescent fire seals are designed to fit into a rebate to either the leaves or the frame of a door. Installation information can be downloaded from the 'DATASHEETS' tab on the product page.
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close