There are many instances in buildings where single or small bunched cables and conduits will need to be positioned through compartment walls. It is important that even the smallest penetrating service is effectively fire stopped to reinstate the fire performance of the wall.

Firepro SpeedSeal is a red putty-based penetration sealing solution available in 60mm and 100mm diameter discs. It has been tested in service openings 25mm x 25mm and 50mm x 50mm to seal penetrating services such as small metallic pipes, plastic pipes, cables and cable bunches.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Installation

Features & Benefits

• Tested to reinstate the fire performance of rigid and flexible walls (minimum 100mm) where small cables and conduits penetrate
• Fire resistance testing to EN 1366-3 and proven to perform for up to EI 60*
• Used to seal penetrations through service openings 25mm x 25mm and 50mm x 50mm
• Tested in conjunction with small/medium metallic pipes, plastic pipes, small/medium cables and cable bunches
• Can be used as a blank seal
• Quick and easy to install
• 2 size options to suit the majority of small openings
• Ideal for refurbishment or new build
• Specifically designed to be used around small cables, cable bunches, plastic and metallic conduits in flexible and rigid walls a minimum 100mm thickness
• Proven by test to provide up to 120 minutes* fire resistance (E120) around services
• Certified by UL

*Subject to application.

Installation

• Please see Product Data Sheet for detailed installation instructions.
• Walls shall be a minimum of 100mm thickness or greater
• Flexible drywalls/partitions shall comprise a minimum of 2 layers of ‘Type F’ Gypsum board on both faces, with minimum 50mm studs
• Solid block, masonry, aerated concrete and concrete shall have a minimum density of 450 kg/m³ and a minimum thickness of 100mm
• All walls shall have at least the same fire resistance as that required of the sealing system
• Services penetrating the division shall be suitably supported via steel angles, hangers or channels, no further than 400mm from the surface of the sealing system on both faces
• Ensure that the aperture size is within the scope of test data, maximum 25mm x 25mm for 60mm diameter and 50mm x 50mm for 100mm diameter SpeedSeal disc
• Check services to be treated are within scope of test data
• All services and apertures need to be thoroughly clean and clear of dust and loose particles
• Temperature to be 5°C or above
• To install, peel protective layer from back of disc and apply SpeedSeal around service, ensuring a close fit
• Install with joint facing in the downwards position where possible
• Press into place with slight compression to ensure a tight fit

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.