Envirograf HW Ultimate Top Coat
Envirograf HW Ultimate Top Coat is a premium quality, satin sheen, coloured finish for the use over Envirograf HW01 White Intumescent Coating:
- Suitable for interior and exterior use on wood
- Low odour
- High opacity finish
- Quick drying and non-yellowing
Envirograf HW Ultimate Top Coat is a premium quality, satin sheen, coloured finish for the use over Envirograf HW01 White Intumescent Coating that is suitable for interior and exterior use on wood. It provides a low odour, high opacity finish that is quick drying and non-yellowing.
Features & Benefits
- Non yellowing
- High opacity
- Quick drying
- Low odour satin finish
Apply 1 coat of Envirograf HW Ultimate Top Coat at 10-12m² per litre for internal use and apply 2 coats for external use.
Avoid the inhalation of dust, wear a suitable face mask if dry sanding. Treat knots with Knotting Solution and prime exposed wood. Special precautions should be taken during surface preparation of pre-1960’s paint surfaces over wood as they may contain harmful lead. For further advice contact the Technical Department.
Stir well before use and apply by brush or roller. Apply liberally and evenly for a smooth finish. Two coats must be used for external use. Do not apply in temperatures below 10˚C or in damp conditions.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
Any Envirograf products to be used in or for Harrods department store should be authorised with our Technical Team prior to purchase.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Roller
- 10 - 12m² per litre
- Touch Dry
- 1 - 2 Hours
|David Walsh on 2019-01-13 14:27:26|| |
I Have an old inch thick, wooden cellar door that needs to be treated with an intumescent paint to comply with HIMO licence requirements. I think it needs two coats , under and top. Ideally just treating the back of the door / cellar side to give 30mins burn protection. This is not an escape route and quite usually humid.
We offer 4 systems to upgrade doors - 2 clear varnish systems and 2 coloured paint finish systems. See full details of each in our Door Upgrade Kits section.