Envirograf HW Enviro Clear Top Coat
Envirograf HW Enviro Clear Top Coat is a specially formulated, quick drying, water based protective top coating for INTERNAL smooth hardwood and softwood surfaces. It can be applied by brush, roller or spray and it comes in either a satin or gloss finish.
Envirograf HW Enviro Clear Top Coat is a specially formulated, quick drying, water based protective top coating for INTERNAL smooth hardwood and softwood surfaces. It can be applied by brush, roller or spray and it comes in either a satin or gloss finish. It can be used over the top of the following Envirograf products:
- HW02E Clear Intumescent Coating
- ES/VFR Clear Fire Protection Coating
- QVFR Clear Fire Protection Coating
Preparation & Application
All surfaces should be clean, dry and free from loose particles and contamination.
Envirograf HW Enviro Clear Top Coat does not need thinning. Stir well before application. The result is dependent on the condition of the surface and temperature of application. The coverage rate is 10-12m² per litre, For hardwearing area’s apply 2 coats.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
Any Envirograf products to be used in or for Harrods department store should be authorised with our Technical Team prior to purchase.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Roller, Spray
- 10 - 12m² per litre
- Touch Dry
- 1 - 2 Hours
|Kyle Monaghan on 2019-08-30 00:26:04|| |
I work at a bar and am looking for a good wood protector for my outside eating area, I have 20 benches and a 20ft bench I wish to sand down and protect this winter. I dont have a way of protecting the benches from the elements so I am looking for a quick drying solution. What products would you recommend??? Kind regards K.monaghan
Assuming you do not require any level of fire protection we would suggest Coo-Var P101 2 Pack Polyurethane Varnish. At 20°C it will be touch dry in 3-4 hours and hard dry in 16-24 hours.
|Timothy Tipton on 2019-01-12 13:20:13|| |
Hi im after fire protection paint for internal door the door i have is already painted white im just wondering what i need I thought the Envirograf HW Enviro Clear Top Coat ? Do i need a undercoat also Or do i need a different product Thanks Tim
Envirograf Door Upgrade Paint System would be our recommendation for your consideration.