Nullifire FC101 Intumescent Coating Repair Filler
Nullifire FC101 Intumescent Coating Repair Filler is a single pack, high build filler based on thermoplastic acrylic resin and hydrocarbon solvent designed specifically for the repair of minor damage to System S Intumescent Basecoats applied to structural steelwork.
- This product is only available for 2-3 day Express delivery on Nullifire/Firetherm orders totalling £75 +VAT
**Available for delivery - see Delivery Options below**
Nullifire FC101 Intumescent Coating Repair Filler can be used internally with Nullifire S602/3/5/6, S607 and S609 Basecoats or externally with Nullifire S605 Basecoat.
Application Check List
When applying Nullifire FC101 Intumescent Coating Repair Filler, ensure that:
- Surface preparation has been carried out correctly.
- The product has been stored under correct conditions.
- Correct equipment is available.
- The site conditions are within specification.
- You are fully conversant with the application instructions and MSDS.
It is recommended that the filler is applied onto areas, which are a maximum of 150mm².
The surface preparation required prior to application of System S Filler is dependent upon the nature of the damage to be repaired.
For minor scratches to basecoat, which has not been topsealed and where there is no damage to primer, then the only preparation required is to abrade any material, which is proud of the basecoat surface and to ensure that the surface is clean prior to Filler application.
Where the damage is more severe, resulting in damage to the primer system exposing bare steel (particularly in external and humid internal conditions), then the primer should be touched up with a suitable anticorrosion primer and allowed to dry, prior to application of System S Filler. It may be necessary to remove a further area of basecoat surrounding the exposed steel to facilitate primer touch-up depending on the scale of damage.
Where damage occurs to basecoat, which has been topsealed, but where the damage does not penetrate through the primer to the steel surface, then the topseal should be abraded back to basecoat for a distance of 50-75mm around the affected area. This is to eliminate the possibility of the Filler overlapping onto topseal.
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
Be the first to ask a question about this product!