Teamac Suregrip Deck Paint

532/G139/ ALL
TEA1270

Teamac Suregrip Deck Paint, is a modified alkyd, ready mixed, aggregated deck coating which provides a rough anti-slip finish when dry.

  • Suitable for:
  • Foot traffic
  • Light truck traffic
  • Use on wood
  • Use on metal
  • Use on concrete
  • Use on GRP
  • Available in a range of colours

Coverage Calculator

Colour
Pick a Colour
  • Current colour: Blue (Aggregated)
Close colour picker
  • White (Aggregated)
  • Light Grey (Aggregated)
  • Grey (Aggregated)
  • Black (Aggregated)
  • Blue (Aggregated)
  • Yellow (Aggregated)
  • Red (Aggregated)
  • Green (Aggregated)
  • Buttermilk (Aggregated)
Size
Finish
£22.46(ex. VAT)
£26.95 (inc. VAT)
Quantity
Please choose your colour
Available for Delivery (See Delivery Options Below)

Description

Teamac Suregrip Anti-Slip Deck Paint is a modified alkyd, ready mixed, aggregated deck coating which provides a rough anti-slip finish when dry. Teamac Suregrip Anti-Slip Deck Paint provides extra protection for crew-members while traversing the deck of a boat in motion or vessel in rough seas. Teamac Suregrip Anti-Slip Deck Paint is a safety coating which can be used inside and outside, where a sure footholding is required.



Click To Jump To Section:




Features & Benefits


  • Suitable for:
  • Foot traffic
  • Light truck traffic
  • Use on wood
  • Use on metal
  • Use on concrete
  • Use on GRP
  • Available in a range of colours



Product Specification


Technical Data
Volume Solids 58 - 62%
VOC Content 343 g/litre
SG 1.35 - 1.55 @ 20°C
Finish Aggregated
Viscostity 6.5 Poise @ 25C
Flash Point above 32°C (closed cup)



Film Thickness Range And Coverage


Product Data
  Dry Film Thickness Wet Film Thickness Theoretical Coverage
Minimum 60 µm 100 µm 6 m2/litre (based on brush application)
Maximum 100 µm 150 µm 10 m2/litre (based on brush application)



The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application



Drying Times


Drying Times At 20°C/RH 50%
Touch Dry: 6 Hours
Dry To Recoat: 16 Hours
Fully Cured: 5 - 7 Days



Low temperature and high humidity will adversely affect application, drying and performance of any coating.



Surface Preparation


  • All surfaces should be clean, dry, sound and free from contaminants
  • Other surfaces have to be prepared and primed with the suitable primer for that substrate
  • Existing painted surfaces - Surfaces should be cleaned, degreased and sanded to ensure an adequate "key" is produced. Remove all loose and flaking material and treat bare areas as new substrate and prepare accordingly



Mixing


  • Stir well before use
  • Do not use mechanical shaker



Thinner


  • Do not thin

Application Conditions


As dictated by normal good painting practice. In confined spaces, provide adequate ventilation during application and drying.



Application Methods


Method Airless Spray Conventional Spray Brush Roller
  No No Yes Yes



  • Nozzle Pressuer: Thinners 14
  • Cleaning Solvent: Thinners 14



Health & Safety


Click to go back to the top of the page

Product Details
1270-920343

Data sheet

Manufacturer
Teamac
For Use By
Consumer Use
Interior / Exterior Use
Interior and Exterior
Interior / Exterior Use
Interior & Exterior use
Water / Solvent Based
Solvent
For Use On
Wood
Metal
Concrete
GRP
Colour
Standard / Ready Mixed
Single, Two or Three Pack
Single
Single, Two or Three Pack
Single
Pack Size
1L
5L
Dry to Recoat (at 20°C)
16 Hours
Coverage
6-10m² per litre
Recommended Thinner/Cleaner
Thinners 14
Solids by Volume
58 - 62%
VOC
343 g / litre
Touch Dry
6 Hours
Finish
Aggregated
Recommended Dry Film Thickness
60
Recommended Wet Film Thickness
100
UN Number
1263
Full Cured (at 22°C)
5 - 7 Days
Base Type
Alkyd
Base Type
Solvent-Based
Exterior / Interior Use
Exterior & Interior Use
Suitable For Use On
Concrete
Suitable For Use On
GRP
Suitable For Use On
Metal
Suitable For Use On
Coated Surfaces
Finish
Aggregated
Application Method
Brush
Application Method
Roller
Manufacturer
Teamac
Components
1K
Usages
Anti-Slip
Product Type
Anti-Slip
Product Range
Suregrip
Type of Wood Finish
Wood Paint
Colour Family
Green
Colour Family
Red
Colour Family
Yellow
Colour Family
White
Colour Family
Grey
Colour Family
Blue
Colour Family
Brown
Colour Family
Black
Colour Family
Cream
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


questions Jane Antoni on 2023-02-25 14:32:10
Question: 

Hi, we want to use this on the deck of our fibreglass boat. Is this a suitable product.

Answer from Rawlins’ Technical Team: 

Assuming the fibreglass is clean, dry, sound and prepared as detailed in the technical data sheet this product can be used.

The area must be thoroughly sanded prior to application.

questions Hani  on 2022-08-06 19:27:41
Question: 

Hi there, I m looking to use this paint for my home decaking . Is this suitable, please ? Is it more durable than standard decking paint ? Do i need to do any special preparation please ? Many thanks.

Answer from Rawlins’ Technical Team: 

Unfortunately no, but assuming a clear anti-slip coating is suitable, the timber decking is bare, clean, dry, sound and prepared as detailed in the technical data sheet we can recommend Coo-Var Suredeck Anti Slip Decking Protector

questions Sally on 2021-09-09 17:39:46
Question: 

Hi, would this be suitable for stone steps in a cellar, the steps are very slippery and never seem to fully dry out? if this is not suitable, could you recommend something? Many Thanks

Answer from Rawlins’ Technical Team: 

Thank you for the enquiry, we have emailed you directly for more information.

questions Mathew Harker on 2021-08-18 14:14:28
Question: 

Do you have a product suitable for decking round the edge of an internal hot tub/hydro pool, that's both protective and slip resistant?

Answer from Rawlins’ Technical Team: 

Assuming the decking is timber, it is clean, dry, sound and prepared as detailed in the technical data sheet we can recommend Smartkote Safekote.

This is a barefoot friendly anti-slip paint.

The first coat should be diluted 10% with Xylene.

questions carolyne  on 2019-11-21 11:33:58
Question: 

Would this be suitable for the floors in the back of vans used as mobile workshops - just concerned about the amount of heat that can build up in the van during sunny days. Thanks.

Answer from Rawlins’ Technical Team: 

As a more durable product that would be much easier to clean we would recommend Smartkote Protectakote UVR which can be applied on to a range of surfaces - some surfaces will need priming though prior to application.

questions Katherine Heath on 2019-03-23 14:29:00
Question: 

Ho, do you do samples? We are struggling to get the colour grey we want so would like a small sample first. Thanks Katherine

Answer from Rawlins’ Technical Team: 

Samples aren't available of this product but we do have a very good colour card for this product which shows the colours and finish of the product very well. If you'd like to provide an address we can post this to you.

questions Stuart on 2018-06-24 08:43:59
Question: 

Will this be ok to use on garden decking

Answer from Rawlins’ Technical Team: 

Pre-tanalised decking will eventually loose adhesion when painted, however if you wish to apply Teamac Suregrip Deck Paint, Jet wash the decking, allow to thoroughly dry and prime with Teamac Wood Primer. Finish with 2 - 3 coats of Teamac Suregrip Deck Paint.

questions Rita on 2017-08-01 21:00:07
Question: It might sound a dull question do u think this will be ok to paint a wooden ladder in a above ground swimming pool
Answer from Rawlins’ Technical Team: 

Teamac Suregrip Deck Paint has a very coarse anti-slip texture and wouldn't be suitable for bare feet or submersion in water. If the ladder is out of water and not subject to bare feet it would be fine.

questions Anna on 2017-01-26 11:59:46
Question: Is this available in more colours? Can the aggregate be added to any of the Teamac marine gloss topcoats?
Answer from Rawlins’ Technical Team: 

Teamac Suregrip Deck Paint is not available in any other colours than the ones listed on our website. You could use Anti-Slip Aggregates in other smooth floor paints available in a wider colour range, or you could over paint Teamac Suregrip Deck Paint with a smooth floor paint once applied to change the appearance.

questions Craig Daniels on 2016-03-15 14:39:06
Question: 

Can I apply the Teamac sure grip with a spray gun?

Answer from Rawlins’ Technical Team: 

No, it is for brush and roller application only. The product has a pre-mixed aggregate in the paint and this will prevent it from being successfully sprayed.

  

Question about the product

* Required fields
(read)
Send

IMPORTANT SHIPPING & DELIVERY INFORMATION

Teamac Suregrip Deck Paint is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.

Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.

Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.

All delivery costs below are excluding VAT


COVERAGE CALCULATOR
Units
Film Thickness
Total area ²
Or enter length and width dimensions:
Length
Width

* All estimates are based on theoretical consumption rates for a single coat and do not take into account any substrate deviations or wastage

You might also like

Teamac Thinner 14

A specially formulated blend of solvents designed to mix with its compatible Teamac or Coo-Var coating to create an optimal consistancy for application. Suitable for use with Brush, Roller or Spray. Teamac Thinner 14 can also be used for the cleaning of some surfaces prior to application of the coating. Also suitable for the cleaning of...

Price £10.61 (ex. VAT)
In Stock and Available for Delivery

Teamac Penetrating Wood Primer White

Teamac Penetrating Wood Primer, is a general purpose, modified alkyd based wood primer for wood, especially useful for priming soft wood. It can be applied to suitably prepared timbers and boards. Overcoatable in 16 hours, it is compatible with Teamac Marine Gloss. Traditional Wood Primer For All Type of Wood. Provides Flat Finish For...

Price £12.04 (ex. VAT)
In Stock and Available for Delivery

Teamac Zinc Phosphate Primer

Teamac Zinc Phosphate Primer, an anticorrosive primer on iron and steel, for use with a range of conventional topcoats such as Teamac Marine Gloss and Teamac Metalcote Plant Enamel. Can be used for: Marine purposes Fire escapes Metal gates Metal garage doors Ideal in coastal areas Click to jump down to Technical Data Coverage...

Price £14.83 (ex. VAT)
In Stock and Available for Delivery

Teamac Suregrip Deck Paint

Teamac Suregrip Deck Paint, is a modified alkyd, ready mixed, aggregated deck coating which provides a rough anti-slip finish when dry. Suitable for: Foot traffic Light truck traffic Use on wood Use on metal Use on concrete Use on GRP Available in a range of colours Coverage Calculator More Information Delivery Info

Price £22.46 (ex. VAT)
In Stock and Available for Delivery