Bradite Acid Etch
Bradite Acid Etch removes excess lime from power floated or very smooth concrete floors, this Acid Etch from Bradite is an ideal pre-treatment for concrete surfaces. Manufactured under the auspices of an ISO 9001:2008 & ISO 14001:2004.
- Pre-treatment for concrete surfaces
- Removes excess lime from power floated or very smooth concrete floor
- Gives improved adhesion to subsequent coatings
**Available for delivery - see Delivery Options below**
Bradite Acid Etch is a mineral acid solution used as a pre-treatment for bare concrete surfaces. Ideal for concrete floors to remove excess lime and/or to etch a surface profile to smooth concrete, providing improved adhesion of subsequent floor coatings.
Car showrooms will find this solution effective for treating concrete before laying down a suitable hard-wearing topcoat, such as Bradite Floor Paint.
Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems.
Features & Benefits
- Pre-treatment for concrete surfaces.
- Removes excess lime from power floated or very smooth concrete floor.
- Gives improved adhesion to subsequent coatings.
- 20m² per litre coverage.
Concrete surface should be cleaned & degreased using Bradite Degreaser TD39 or steam cleaning, before application of Bradite Acid Etch TA37. Apply evenly using a soft brush and allow approximately 10 to 20 minutes to react. Two or more applications may be required depending upon the amount of laitance present.
After the reaction has taken place the surface should be thoroughly rinsed with clean water to remove all loose particles and soluble salts. Rinsing should continue until surface shows a neutral or weakly alkaline pH when tested with litmus paper. Treated floor should then be allowed to thoroughly dry prior to vacuum cleaning to remove dust and all subsequent painting operations.
Brush: supplied ready for use.
Spraying: this product should not be sprayed under any circumstance.
Clean all equipment immediately after use with clean water for best results.
Always refer to the Health and Safety sheet for the product before use, and observe the warning phrases on the label.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
- Interior / Exterior Use
- For Use On
- Tile, Block Paving, Brickwork, Wood
- Application Method
- Single, Two or Three Pack
- Pack Size
- 5L, 25L
- 20m2 per Litre
Be the first to ask a question about this product!