Coo-Var Acid Etch
Coo-Var Acid Etch is a careful blend of acids and wetting agents in solution, used to clean and ‘etch’ concrete/mortared floors and pools prior to painting. Used to prepare new and smoothed concrete.
- Removes laitance from concrete/render
- Removes salts from concrete/render
- Can be used as a degreaser
- Removes patches of oil and grease.
- Essential for good adhesion
Coo-Var Acid Etch is a careful blend of acids and wetting agents in solution. Acid Etch removes residual laitence from all new concrete - use prior to painting. Removes laitence and salts from concrete and render. Should be used to prepare exceptionally smooth surfaces and power floated concrete floors where blasting and mechanical abrasion is not practical.
Clear and sweep the area to be etched to remove debris. Ensure surface is free of oil and grease before application.
Dilution guide. Mix 1 part Coo-Var Acid Etch with 3 parts water, further applications may be necessary depending upon the severity of etch/cleaning required.
See Health and Safety data sheet for suitable personal protective equipment. When the Acid Etch is applied it begins to react with the surface and will bubble as the reaction is carried out. When the bubbling has stopped then the reaction is complete and the remaining neutralised acid should be washed away with fresh water. Allow to dry completely before attempting to paint the surface.
Suitable Coo-Var top coat.
Essential for good adhesion of paint where mechanical abrading is not possible.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- For Use On
- Application Method
- Brush, Mop, Watering Can
- Single, Two or Three Pack
- Pack Size
- Base Type
- Mixing Ratio
- 1 part Coo-Var Acid Etch with 3 parts water
- Brush, mop or sponge pad
- 7m² per litre
- Recommended Thinner/Cleaner
- UN Number
Be the first to ask a question about this product!