Coo-Var Dampshield is a two-component epoxy resin membrane that is tolerant to residual moisture in concrete floors. This enables earlier access onto the floor than would otherwise be available for the application of screeds, coatings and other floor coverings including carpets, tiles, vinyl and wood.
- Enables resin finishes sooner
- Easy application
- Can be applied to substrates with hygrometer readings up to 97% RH
- Solvent free
- Low odour
- Can be used on concrete floors and fine concrete screeds
Coo-Var Dampshield is a two-component resin membrane that is tolerant to residual moisture in concrete floors. This enables earlier access onto the floor than would otherwise be available for the application of screeds, coatings and other floor coverings including carpets, tiles, vinyl and wood. Being solvent free it is low odour during application which allows usage in areas where taint could be a problem.
Coo-Var Dampshield can be used on concrete floors and fine concrete screeds, in the case of unbonded screeds this should not be less than 50mm thick. The surface must be of sufficient quality, continuity and mechanical strength to ensure an even coating.
Concrete surfaces must be prepared by scarifying, vacuum shot-blasting, planing or other suitable method. All traces of concrete hardeners or other contaminants must be removed. The surface must be thoroughly vacuumed to remove concrete dust and then protect against further contamination by suitable means. Surfaces must be free from liquid, water, and the atmosphere must not be condensing.
Mix the contents of the hardener component with the base thoroughly using a slow speed power strirrer.
As dictated by normal good painting practice. Do not apply if the temperature is likely to drop below 10 °C during application or during the drying process.
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Base Type
- 4m² per KG
- Recommended Thinner/Cleaner
- Thinners 16 (brushwash only)
- Solids by Volume
- Touch Dry
- 24 Hours
- UN Number
Be the first to ask a question about this product!