Nitodek FS Primer is a transparent, solvent-free, 2-component methacrylic resin that cures rapidly, even at low temperatures, on steel and new and existing concrete surfaces.
Part of the Nitodek FS system
Fast setting allows for quick over-coating
Easy to apply
Suitable for priming vertical and absorbent substrates
The quantity of hardener to be added to Nitodek FS Primer Resin must be adjusted dependent on the temperature of the substrate. For the exact quantities, please refer to the table “Nitodek FS Hardener dosages” in the data sheet.
Do not under-dose the hardener powder, as this will lead to curing problems. Do not overdose the hardener powder, as this can also lead to serious curing problems.
Observe the recommended mixing quantites to avoid flash setting of the material in the pot before it can be fully applied. This also ensures good penetration of the primer into the substrate. The mixed material must be applied as soon as the hardener powder has been properly dispersed into the resin component.
Nitodek FS Primer must be applied evenly without leaving puddles by means of a squeegee, paint roller or brush. If rubber blades are used, the surface must always be rolled with a paint roller afterwards. Matt and heavily absorbent patchesmust be re-primed wet-into-wet before hardening until the pores are closed up. Resin consumption is about 0.4 kg/m2. Nitodek FS Primer must be allowed to properly cure before over-coating.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
Fosroc Nitodek FS Primer is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
Fosroc Polyurea WCS is a cartridge-packed, 100% solids, flexible, two-component, rapid curing Polyurea system. Designed for use as a fast setting elastomeric waterproof coating and seam seal.Standard Grade is low pressure spray or pour-applied, designed as a waterproofing and protective coating for small areas including repair work. It...