

Sikafloor ProSeal is a one component high performance curing, sealing and hardening compound for concrete floors from the Sikafloor product range - the original and the best!
Features and Benefits
Sikafloor ProSeal is a solvent based, clear acrylic resin polymer solution used to cure, harden and seal fresh or hardened concrete. Suitable for interior and exterior applications.
Uses:
Features and Benefits:
For more details please download the product data sheet from the 'DATASHEETS' tab above.
Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.
![]() | Question:
Which product is best for a recently laid (1 week ago) very smooth power-floated domestic concrete floor? This will be the final surface. Ie not to be tiled or painted so a slight sheen would be ideal but not looking for a gloss. We are in NW Highlands and the building is wind and water tight but we have relatively low temps and very high humidity at this time of year. Hard to see it staying above 4-5 degrees for much longer and could be colder overnight. Grateful for advice, Bernard |
Answer:
This sealer and many others require the substrate temperature to be above 10°C for application and at least 3°C above the due point to reduce the risk of condensation during curing which could cause blooming of the floor finish. This product will leave a sheen to the surface, we would not advise application till the substrate and air temperatures are within the parameters detailed in the Technical Data Sheet, at this point the concrete may of fully hardened and would require preparation by grinding prior to application. There are other 2 pack clear floor sealers that could be suitable for this application but these will require the concrete moisture content to be less than 5% and will not be suitable for application till the temperatures also rise. | |
• These colour samples are to be used for guidance only.
• Product contained within is generic to provide a close representation to your chosen colour.
• Should not be used to carry out any painting project, this is for colour selection purposes only and does not remove the need for you to ensure the correct product is chosen and tested for your application once a colour has been decided on.
• It is not a sample of the product you intend to purchase/use and cannot be used to test anything other than colour appearance.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application, batches variances number of coats and substrate surface.
• We cannot therefore promise that the colour of the product you ultimately purchase will exactly match the colour of this colour sample.
• Once you have selected a colour, you must purchase the smallest amount of the product you intend to use in your chosen colour and apply to a small, inconspicuous test area to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.
• Notwithstanding any other provision of our conditions of sale, you agree and understand that many factors affect the colour of a painted product, including lighting, sheen level, method of application and product surface.
• We cannot therefore promise that the colour of the product you paint with the Kolorbond paint will exactly match the colour of the item you send to us.
• You must therefore purchase the smallest Kolorbond paint pot available first and then apply the paint to a small, and where possible hidden, test area of your product to be sure that it meets your expectations.
• Leave the product for 24 hours and then only buy more paint and/or apply more paint to your product if you are completely happy with the results on the test area.
• We cannot be liable to you for any loss or damage if you have not complied with this process.