Please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for specific advice.

Coverage

• A 10kg pack will be sufficient to coat an area of 10m² at a rate of 1kg/m²

Surface Preparation

• Asphalt and Tarmac surfaces must be clean, dry and free from contaminants
• New Asphalt and Tarmac must be allowed to ‘weather’ to ensure any excess oils are released
• Mechanical preparation is not normally necessary, however vacuum shot blasting can be employed to clean the surface should this be required, and will provide a better mechanical ‘key’ in heavy duty environments

Priming:

• No primer required for Asphalt and Tarmac surfaces
• Prime using 706 MMA Floor Primer on concrete (please refer to 706 MMA Floor Primer data sheet)
• Damp concrete surfaces can be primed using 709 MMA Damp Proof Primer – refer to product data sheet for full details
• Steel surfaces can be primed using 707 MMA Metal Primer – refer to product data sheet for full details

Mixing:

• 702 MMA Flexible Floor Coating is supplied as a two pack material consisting of the resin component, and the catalyst component
• Incorporate the catalyst component under mechanical stirring and mix for 1-2 minutes

Mixing Ratio:

• (% Catalyst by Weight) = 2

Application

• Apply 702 MMA Flexible Floor Coating using short nap perlon or smooth lambswool rollers at a nominal rate of 0.4 – 1.0kg/m² depending on substrate profile and desired thickness
• Should a slip resistant finish be required then broadcast 504 Standard Anti Slip Aggregate onto the first coat within 10 minutes of application
• Following a minimum of 1 hour, sweep off excess aggregate, and apply a second coat of 702 MMA Flexible Floor Coating.

Cleaning

• Clean equipment with 109 Tool Cleaner immediately after use

Curing

• Light Foot Traffic: 2 hours @ 20°C
• Full chemical resistance: 24 hours @ 20°C

Limitations

• Do not apply to damp substrates

702 MMA Flexible Floor Coating will taint food during application, so that all foodstuffs in the immediate vicinity must be removed or properly covered

Storage & Shelf Life

• Store in dry conditions, out of direct sunlight, at temperatures between 10°C and 20°C
• Adequate ventilation of the storage area should be provided
• Keep container tightly closed when not in use
• 702 MMA Flexible Floor Coating has a minimum shelf life of six months when stored in original, unopened containers in accordance with manufacturer’s instructions

Health & Safety

702 MMA Flexible Floor Coating flammable during application, so adequate safety precautions should be observed.

• Avoid contact of the material with skin and eyes
• Wear gloves and goggles
• Wash off splashes immediately with soap and water
• Any eye contamination must be rapidly irrigated with copious amounts of clean water, and immediate medical attention sought
• Please refer to Material Safety Data Sheet for additional information
• 702 MMA Flexible Floor Coating shall be applied strictly in accordance with the manufacturer’s instructions

For specific advice regarding any aspect of this product, please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]