Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Preparation
• Application

Features & Benefits

• Available in more than 350 colours in RAL & BS
• High performance single pack chlorinated rubber floor paint
• Excellent water and good chemical resistance
• For use on concrete and steel floors
• Can be used with Bradite Low Slip Additive LS30 to provide additional under foot traction
• Manufactured under the auspices of an ISO 9001:2008 quality & ISO 14001:2004 environmental management systems

Preparation

• For internal and external steel or concrete and other external mineral substrates, which are dry, free of efflorescence laitance and have been properly prepared
• Compatibility with existing coatings should be confirmed by preparing and painting a test patch. External floor surfaces may be suitable (well above local water table and/or an intact DPM barrier present)
• Substrates should be dust free and completely dry before coating. When painting concrete it is vital to ensure that the substrate is completely dry and free of laitance
• If the concrete is loose, chipping or has concrete dust present, the coating will not perform properly unless all loose material and dust is removed and damaged areas are repaired
• Power floated, shiny or unpainted non porous concrete floors should be thoroughly vacuum blast cleaned to a roughness profile of 30-50 microns, or acid etched using Bradite Acid Etch TA37, or primed using Bradite Floor Primer ES40
• High pressure water cleaning should be utilised to remove all loose and flaking paint and contamination back to a sound substrate. Bradite TD39 Industrial Degreaser should be used if necessary to remove all grease and oil
• Intact areas of existing coatings should be roughened by abrasive manual or disc rubbing and feathered back to a sound coating edge. Cracks and pits should be filled using a suitable screed or mortar before painting

Application

• Application and use should always conform to the codes of practice described in BS 6150 and BS 5493
• For application on concrete or other absorbent substrates, the first coat should be thinned 15-20% with Bradite Thinner TC32 to allow penetration into the substrate
• For maintenance painting the 1st coat will be a touch up to bare areas
• Applicable by brush or roller. Spray is not recommended for this product
• Supplied ready for use. Thin, if required, with 0 - 5% Bradite Thinner TC32
• For additional underfoot traction, Bradite Low Slip Hard Aggregate LS30 should be added to the paint and mixed thoroughly just before use at a rate of 1 x 250ml LS30 tin (400g) per 5 litre of paint
• Clean all equipment immediately after use with Bradite Thinner TC32 for best results
• Surface dry in 1 hour. While the coating will take light foot traffic after overnight drying, full cure may take 4 days at 20°C, and should not be subject to heavy traffic for at least 24 hours. Please note that drying/curing times will vary depending on film thickness, temperature and relative humidity