603 Thermoplastic Lines
Condition: New product
Manufacturer: Rawlins Paints
An easy to apply, preformed thermoplastic road and surface marking material. Ideal for fast permanent installation or re-instatement of road markings, car park markings and cycleways.
603 Thermoplastic Lines are an easy to apply, preformed thermoplastic road and surface marking material. Ideal for fast permanent installation or re-instatement of road markings, car park markings and cycleways.
603 Thermoplastic Lines require only one person and a gas torch to install and are extremely flexible.
Features & Benefits
- The most durable line marking system we offer
- Easy to apply by gas torch
- Can be trafficked within minutes of application.
- Professional, durable, highly visible results
- Easy to apply yourself with basic equipment
- Efficient – minimal waste, buy only what you need
- Practical to use in hard-to-reach spaces
- Anti-Skid & Reflective additives available
- Consistent material colour throughout
- Areas requiring demarcation including but not limited to - factory units, car parks, roads, walkways, playgrounds, etc.
- Bare tarmac, asphalt and concrete floor surfaces
- Interior & exterior
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Touch Dry||10 Mins|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
|jay egan on 13/02/2018|
How long do you need to burn 603thermoplastic line
Download the '603 Line PDS' document above, this gives detailed application instructions on pages 1 and 2.
|Bill Morris on 25/05/2017|
Question: How long are the rolls?
603 Thermoplastic Lines are supplied in 5 metre rolls in various widths.
|S snape on 22/03/2017|
Question: When applying line paint from a roll does the side with the blue film go up or down to ground
The markings should be placed in position with the protective plastic film uppermost. The plastic film is then removed and heat is applied with a blow torch when ready to apply.
Full application instructions can be found in the product data sheet available to download from the 'DATASHEETS' tab on the product page.
|Martin Dudley on 01/02/2017|
Question: Can this product be used on block paviers? if so is any primer needed?
Yes, as long as the surface is primed first with 605 Thermoplastic Tack Primer.
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close