The Watco Thermoline system combines the longevity and excellent adhesion of thermoplastic with ease of application. It is designed for roadways, warehouses, pavements, car parks and any heavily trafficked areas.

The lines are supplied in 1m and 5m lengths for easy handling. The line or symbol is laid on the substrate and heated using the Watco Thermoline Blow Torch (available separately). The exceptionally clear, well-defined markings can be driven over within minutes.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application

Features & Benefits

• Suitable for internal and external use
• Lines and symbols are pre formed - no cutting required
• Quick application - one man operation
• Ready for use within minutes
• Tough, flexible, permanent markings
• Can be applied to most surfaces including concrete, tarmac, asphalt, brick, masonry, metal and similar surfaces

Application

Position warning signs and cones if necessary and ensure all vehicles are removed from the working area. The surface of the road must be dry and clean. If there is any surface water, sweep this away and dry out dampness with a torch. If the ground in cold, heat with the blowtorch before laying the markings. This will aid adhesion to the surface of the road.

Remove the PROTECTIVE PLASTIC FILM and place into position. When laying lines, ensure they are ‘butted’ up correctly and straight.

Set regulator at 25psi, ignite and turn torch on to required pressure. Position nozzle of blowtorch 4-6 inches above the centre of the marking at one end. With a ‘pendulum’ motion from side to side, bring the material to a fluid state so that the marking bubbles and then proceed down the marking using the same action.

Care must be taken in the speed of the bonding. Too slow and the marking may burn, too fast and the marking may not bond. If the flame is too high and incorrectly angled, it is possible to distort the markings.

Good application can be achieved with experience. If the marking is multi-layered apply base layer first and allow to cool. Then position the second layer and repeat the fixing instructions.

Allow material to cool before removing cones. If fast cooling is required, it is suggested that water may be sprayed over the markings.