508 Fine Particle Anti-Slip Additive is a micronized polymer bead which can be added to coatings and sealers to impart a lightly textured finish, which increases slip resistance.
The rounded shape of 508 Fine Particle Anti-Slip Additive provides optimum abrasion resistance without sharp edges, allowing ease of surface cleaning.
The product is also gentle on bare feet, allowing its use on pool decks and patios etc.
This product is for Professional Use Only.
The product comes in three grades;
- 125 micron
- 250 micron
- 500 micron
Quick Links - Click To Jump To Section:
Features & Benefits
- Increases slip resistance
- Added to coatings and sealers to impart a lightly textured finish
- Provides optimum abrasion resistance without sharp edges
- The product is gentle on bare feet, allowing its use on pool decks and patios
- Comes in three grades
- Non-Toxic
- Controlled particle distribution gives uniform finish
- Economical
- Good balance between slip resistance and ease of cleaning
Pack Sizes 
Supplied in pre-weighed amounts corresponding to the size of the pack it is being added to.
Generally, this is 200g per 5kg/lt of coating.
Please note:
- The 125 micron grade is generally used in single pack coatings and sealers only.
- The 250 micron grade is used primarily for two pack water based and solvented coatings.
- High build coatings often use the larger 500 micron grade size - however care must be taken with this size with dispersion and application to ensure even distribution and uniform appearance.
Recommended Uses
In coatings and sealers to impart a lightly textured finish that increases slip resistance. E.g. Factory floors, driveways, garages, wet rooms etc.
Procedure
508 Fine Particle Anti-Slip Additive is added to the mixed coating and stirred thoroughly prior to application.
PTV Results
A wet PTV of >36 is considered 'low slip potential'. The 250 micron grade was used for all of the above tests at an addition rate of 2.4%.
As a guide we can offer an indication only (not tested) of other products performance in our range from the addition of 508 Fine Particle Anti-Slip Additive as follows:
Many variables can affect a products slip resistance performance so we always recommend a consultation with our Technical Team (0113 2455450 (option 2) or [email protected]) prior to choosing and using a product/system for your product.
Health and Safety
Please refer to Material Safety Data Sheet for additional information.
508 Fine Particle Anti-Slip Additive shall be applied strictly in accordance with the manufacturer's instructions.
For specific advice regarding any aspect of this product, please consult our Technical Department.