402 WG Damp Proof Coating
Manufacturer: Rawlins Paints
402 WG Damp Proof Coating is a fast curing version of 402 Damp Proof Coating designed to be used in lower temperatures or when rapid overcoating/access is required. Developed to function as a rapid curing, residual construction moisture suppressant, to allow the early installation of moisture sensitive flooring in fast track building programmes.
402 WG Damp Proof Coating has been developed to function as a rapid curing, residual construction moisture suppressant, to allow the early installation of moisture sensitive flooring in fast track building programmes. One or two coats may be applied depending on the degree of dampness present in the sub-floor.
402 WG Damp Proof Coating is a two component Epoxy-Polyaminoamide based material. The product is available in grey, red, and clear colours to allow control of uniform coverage. It is also suitable for priming damp, minimally prepared substrates, and as a high build coating in its own right.
- Provides a surface damp-proof membrane
- Allows rapid laying of floor toppings to power floated concrete
- Solvent free, low odour
- Coloured to monitor progress
- Low viscosity, easily applied
- Excellent adhesion to very damp surfaces
- Surface tolerant
- Excellent resistance to water, grease and oil
- Rapid Cure
- As a surface damp-proof membrane.
- As a moisture suppressant on concrete and sand/cement screeds.
- As a damp tolerant primer for concrete and resin screeds.
- As a fast curing protective coating for concrete or steelwork.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Typical Coverage (per coat)||3-4m² per kg|
|Touch Dry||2 Hours|
|Application||Brush, Roller, Spray|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close