Smartkote Protectakote 2K Metal Primer
  • Smartkote Protectakote 2K Metal Primer

Smartkote Protectakote 2K Metal Primer

ZPR2KBASE1L/ZPR2KACT0.5L

Smartkote Protectakote 2K Metal Primer is a dual component etch primer suitable for achieving adhesion of polyurethane to all types of aluminium as well as all other metal types where adhesion is problematic. Protectakote 2K Metal Primer is suitable for applications involving complete immersion in water.

Colour
Size
£31.00
VAT excluded

£37.20 Tax incl.
Quantity

Description

Smartkote Protectakote 2K Metal Primer is a dual component etch primer suitable for achieving adhesion of polyurethane to all types of aluminium as well as all other metal types where adhesion is problematic. Protectakote 2K Metal Primer is suitable for applications involving complete immersion in water.

Features & Benefits

  • Free of toxic zinc chromate
  • Fast drying
  • Neutral colour
  • Waterproof

Product Uses

  • Aluminium walkways and steps
  • Hydraulic lifts
  • Metal railings
  • Stainless steel items
  • Galvanized items
  • Aluminium boats
  • Glazed ceramic tiles
  • Inside metal tanks
  • Pipes and fittings, etc.

Surface Preparation

  • Clean and degrease the metal thoroughly before application.
  • If oxides are present, a light sanding may be necessary. Use P180-P250 grit sandpaper, removing sanding dust with a solvent wipe.
  • Allow to dry thoroughly before application.

Application

Mix the preweighed packs together in a suitable container and when homogeneous commence application. If the packs are to be split into smaller quantities, observe the mix ratios given below.

Mixing ratio

  • 100:50 by mass (2 to 1)
  • 100:66.7 by volume (1.5 to 1)

Apply a single coat by brush, roller or spray keeping the product as thin as possible. Spray using a 1.5mm nozzle and pressure of 3-4 bar.

  • Drying time: 10 minutes at 25°C
  • Overcoating: after 30 minutes and before 24 hours
  • Protectakote 2K Metal Primer is not suitable for thermoplastic acrylics and NC products.

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details
ZPR2KBASE1L/ZPR2KACT0.5L

Data sheet

Application
Brush, Roller, Spray
Coverage
8 - 10m² per litre
Touch Dry
10mins
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


Be the first to ask a question about this product!


Question about the product

* Required fields
(read)
Send
16 other products in the same category:

RSL Resuprime PU

Resuprime PU, a two component, solvent free polyurethane primer designed for use on car parking decks and other areas where a more flexible solution is required, with excellent adhesion to a wide variety of substrates. Its degree of flexibility compliments the properties of the Resudeck ID and Resudeck TD systems. Good flexibility High...

Price £112.00
In stock

Britannia Concrete Floor Sealer

Concrete surfaces naturally dust and powder. In some cases this is not a problem, but there are many environments where this dusting would pose a significant problem, such as in commercial kitchens and laboratories. Advantages of Dust-proofing Reduction of contamination Health & Safety Cleanliness

Price £35.75
In stock

Remmers Epoxy Quick 100

Remmers Epoxy Quick 100 is a very fast reacting, transparent epoxy resin that is used as a primer, for levelling layers and for the production of compression resistant mortars beneath coatings. Can be subjected to heavy mechanical and chemical loads Ideal for consumer markets; Workshops Fabrications halls Assembly areas Food industry...

Price £66.60
In stock

Duram Duraprime

Duram Duraprime is a water-based epoxy primer that treats and seals surfaces in preparation for later waterproofing. It can be used on both damp and dry surfaces and is especially effective for priming new concrete as it penetrates the surface, forming a strong, waterproof bond and allowing for easy overcoating

Price £22.46
In stock

Blackfriar Professional Oil Tolerant Primer

Blackfriar Professional Oil Tolerant Primer is a specialist primer for surfaces with residual oil contamination. Ideal for concrete floors and screeds, promotes adhesion prior to coating with with Blackfriar Professional High Traffic Floor Paint. Product Details Designed for use over cleaned concrete floors and screeds. Tolerates all...

Price £91.11
In stock

Hydron Nu-Base PU Floor Seal

Nu-Base PU Floor Seal is a specially-formulated floor sealer that protects the concrete or brick surface from absorbing foreign material, such as oil, grease, dirt, water and a wide range of chemicals. Advantages Hard-wearing and chemical resistant Clear finish Perfect for factories, car parks, garages and driveways

Price £73.00
In stock

SCHÖNOX SDG

SCHÖNOX SDG is a very low emission special dispersion primer ready for use, suitable for the fast pre-treatment of unheated cementitious screeds with increased residual moisture up to 4.0 CM-% (85%-rh).

Price £158.13
In stock

RSL Resuprime ZP

Resuprime ZP, is a two-pack, high solids epoxy resin zinc phosphate primer coat principally designed to bond thin section resin based screeds and toppings to steel and ferrous structures, and is recommended for use as an anti-corrosion primer for Sherwin-Williams flooring products and on mezzanine areas, bridge decks, loading bays, ramps and...

Price £70.80
In stock

Sikafloor 03 Primer

Sikafloor 03 Primer is a very low emission, ready to use dispersion primer with high penetration for mineral substrates as moisture protection. Intended for application to interior and exterior surfaces prior to the application of levelling compounds. It is suitable as a primer on gypsum and cement based substrates, as an intermediate primer...

Price £53.78
In stock

RSL Resuprime MVT

RSL Resuprime MVT (formerly known as R.S. Dampshield FH) is a faster curing version of R.S. Dampshield, with overcoat times of 6 hours. A two-component epoxy resin primer, it enables even earlier access onto new or existing concrete substrates for screed and coating applications on carpets, tiles, vinyl and wood.  Features and Benefits:...

Price £19.80
In stock

Sikafloor 161

Sikafloor 161 is an economic two-part epoxy primer, levelling mortar and intermediate layer epoxy resin primer for Sikafloor systems and a binder for Sika levelling mortars and screeds. Features and Benefits Moisture tolerant Low viscosity Good penetration Excellent bond strength Easy application Short waiting times Solvent-free...

Price £119.26
In stock

Remmers Pore Filler

Remmers Pore Filler is a high-viscosity one component copolymer acrylate dispersion. This thixotropic transparent and non-yellowing synthetic grout is used to seal the pores of quartz or stone carpet floors.  Used to seal the pores of aggregate floors in toilets, kitchens After curing, a PU-topcoat or epoxy-topcoat can be applied. This is...

Price £145.98
In stock

Sikafloor ProSeal 90

Sikafloor ProSeal 90 is a curing and sealing compound for concrete floors. It is a one component Sikafloor product that has higher efficiency curing, sealing and hardening liquid and is suitable for exterior and interior application. Features and Benefits  Suitable for exterior and interior application Excellent moisture retention; meets...

Price £318.88
In stock

Jotun Jotafloor Sealer

This product is now only available with a minimum order of 800 litres. For an alternative, please contact our sales team on 0113 2455450 or via the contact form. Jotun Jotafloor Sealer is a sealer/primer for all Jotafloor products. Specially designed for use independently as a dust binder for concrete floors. Recommended for warehouses,...

Price £38.61
In stock

Jotun Penguard Clear Sealer

Jotun Penguard Clear Sealer is a two component transparent polyamide cured high molecular weight epoxy sealer coating that has excellent penetrating properties and is designed as a sealer coat for concrete surfaces. Can be used as primer or finish coat in a complete system in atmospheric environments.

Price £51.34
In stock

Everbuild 908 DPM

A ready to use, odourless, rubber enriched bitumen emulsion providing a highly effective damp-proof membrane

Price £52.46
In stock