Sika Primer MB is a primer and moisture control coating for cementitious substrates prior to levelling or bonding with elastic sikabond adhesives. Sika Primer MB is a one coat, 2-part, solvent free, low viscosity, epoxy resin primer for use in conjunction with Sika Schönox levelling compounds, dispersion primers and SikaBond Wood Floor adhesives.
Hydron Nu-Base Epoxy Floor Primer
Nu-Base Epoxy Floor Primer has been specifically-formulated to cure in damp conditions, making it an ideal choice to prime structures such as subways and multi-storey car parks, where moisture can linger. Upon proper application, this primer will act as a damp-proof membrane on the floor.
- Cures in damp conditions
- 3-5m²/KG coverage
- "Straw" in colour
Nu-Base Epoxy Floor Primer is ideal for priming floors in damp and cold conditions, such as multi-storey car parks and subways. Despite the damp conditions, this primer will still cure. Being epoxy-based, it will provide a tough undercoat on which to apply the topcoat.
Assuming no water pressure is applied, the Nu-Base Epoxy Floor Primer will act as a damp-proof membrane.
Product Use in the Workplace
- Multi-storey car park - Hundreds of cars wheeling-in rainwater and debris daily, combined with rainfall working its way in can puddle on uneven car park flooring. Sheltered from the sun, and acting as a wind tunnel, these concrete car hotels are prime candidate as a cold and damp environment which can make applying a protective coating tricky. This specially-formulated epoxy primer is designed for use in such damp and cold environments.
- Subway - Cold. Damp. Dreary. No sunlight. This all equates to an environment that needs an epoxy-based floor sealer that is ideal for such environments. Once primer has dried, the topcoat can be applied.
Features & Benefits
- Will cure under damp conditions.
- "Straw" in colour.
- 3-5m²/KG coverage.
- 12-month shelf life.
New floors must be clean, dry and fully cured. Shot blast to provide a surface profile and ensure penetration. Old floors remove all dirt, oil, grease and other contamination by shot-blasting, scarification or mechanical planning.
By brush/roller or airless spray. All equipment should be cleaned with Nu-Base Epoxy Thinners. Conventional thinners and brush cleaners are not effective.
Recommended storage is in a cool, dry place with temperatures between 10-15°C, and in accordance with the Highly Flammable Liquids and Liquefied Petroleum Gases Regulations 1972.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Brush, Roller, Spray
- 3-5 m²/KG
- Touch Dry
- 6 hours @ 20°C
Be the first to ask a question about this product!
Sika Stone Protector is a water based sealer suitable for all forms of natural stone. It can be used internally or externally to resist stains without changing the aesthetic look of the surface. Suitable for use on natural stone including Indian sandstone, granite, slate and limestone. Ideal for use on paths, patios and block paving. Solvent free no VOC’s.
Remmers PUR UV 100 is a pure unfilled and unpigmented polyurethane resin binder that is used as a fully stable binder for quartz, stones, pebbles and other aggregates, particularly when used outside or where complete UV stability and a degree of flexibility is required. A highly flexible grade (80% elongation) is available upon request (note:...
Remmers PUR Aqua Top 500 2K M is a water based, silk matt, transparent, 2-component sealant with very good resistance to UV and chemicals, extremely little tendency to soil and little susceptibility to scratches and is extremely resistant to hot automobile tyres. A silk matt sealant for all Remmers Epoxy and PUR coatings. Image already added
Sikafloor 03 Primer is a very low emission, ready to use dispersion primer with high penetration for mineral substrates as moisture protection. Intended for application to interior and exterior surfaces prior to the application of levelling compounds. Sikafloor 03 Primer is suitable as a primer on gypsum and cement based substrates, as an intermediate...
Resustat Primer is designed to be applied prior to the use of Resustat ESM, Resustat SL23, Resustat TG69 or Resustat Terrazzo. It is a low viscosity epoxy primer with conductive fillers. ADVANTAGES Conductive with very low electrical resistance Good adhesion Low odour High solids Easy to apply Image already added
R.S Screed Seal is a two-pack epoxy resin surface coating for use with other RSL and Sherwin-Williams products, filling any voids, pockets or interstices exposed in the surface. ADVANTAGES Enhances chemical resistance Prevents water spillage Improves cleanability Hygienic No shrinkage on curing Can be used decoratively Colour stability Image...
SikaBond PVA+ is a general purpose economic adhesive, sealer and mortar improver for concrete, render and plasters. Reduces surface dusting and conforms to BS 5270 for internal plastering. Highly effective and easy to use building adhesive, primer, admixture, bonding agent, sealer and dustproofer. For use on a wide range of building jobs as a general...
Remmers PUR Top is a range of thin film polyurethane seal coats for synthetic resin coatings with exceptional scratch resistance. The products are available in three gloss levels used to impart a tough lacquered finish to resin floors to minimise scratching, impart specific matt/gloss levels. A 'Plus' version is available which offers...
401 Epoxy Floor Primer is a clear primer, especially formulated to provide excellent adhesion to a variety of surfaces prior to the application of our coatings or as a clear sealer in its own right. Used to maximise the performance, adhesion and spreading rates of our systems it can even be applied to damp concrete.
Rust-Oleum Powerfloat Epoxy Floor Primer Rapid 3366 is a rapid curing 2-component solvent-free epoxy primer designed to improve the adhesion of coatings to difficult substrates such as power-floated concrete.
Rust-Oleum 7201 Universal Floor Primer is ready for use solvent based adhesion primer based on a special epoxyester binder. Improves the adhesion of floor paints on mineral substrates. 1 component, easy to apply it can be recoated with all Rust-Oleum or Mathys floor paints.
Resujoint V is a flexible, thixotropic, two-component epoxy joint sealant designed to accommodate low level movement in vertical and horizontal joints. ADVANTAGES Tough, yet flexible Adhesive Easy to clean Good chemical resistance Accommodates movement Maintains a seamless finish
Remmers PUR Aqua Top 1K is a single component, glossy, clear fixation layer and sealant for indoor areas used for transparent fixation and sealing of flake covers. PUR Aqua Top 1K is a water based, glossy, transparent, non-yellowing, fast drying, single component sealant. Image already added