404S Epoxy Metal Primer is a two pack, high solids, epoxy, anticorrosive primer designed for the protection of steelwork, aluminium and galvanising.

Whilst optimum performance will only be achieved by applying to well-prepared substrates, 404S Epoxy Metal Primer will adhere well to minimally prepared surfaces. 404S Epoxy Metal Primer has a long overcoating window and provides excellent corrosion protection.

This product is for Professional Use Only.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Typical Properties
• Coverage
• Surface Preparation
• Application
• Cleaning
• Curing
• Limitations
• Storage & Shelf Life
• Health & Safety

Features & Benefits

• Anticorrosive primer designed for the protection of steelwork, aluminium and galvanising
• High Solids (>80%)
• Fast drying - touch dry following 4 hours cure @ 20ºC
• May be applied to damp or dry surfaces
• Excellent anti-corrosive properties
• Compatible with a wide range of top coats
• Long overcoating window - up to a maximum of 3 months
• Easily applied and good adhesion to the substrate
• Can also be used as a holding primer for grit blasted metal surfaces
• Two-pack

Typical Properties

Coverage

• 1 litre of 404S Epoxy Metal Primer will be sufficient to treat 8-10m² of surface, achieving an overall dry film thickness of 80-100 microns

Surface Preparation

Steel/Galvanised Steel:

• Any rust, mill scale and other contaminants should be removed by grit blasting to Swedish Standard Sa 2.5
• Reduced levels of surface preparation, e.g. wire brushing to remove loose rust, are permissible, but may lead to lower performance levels
• New galvanised steel or aluminium may be abraded and solvent wiped

Mixing:

• Pour the contents of the curing agent container into the base container and thoroughly mix, preferably by mechanical means until a uniform colour is achieved

Mixing Ratio:

• By Volume - 4 Base: 1 Curing Agent

Application

• Apply the material by brush, roller or airless spray, at a nominal rate of 8-10m² per litre per coat

Cleaning

• Clean equipment with 109 Tool Cleaner prior to curing of the coating

Curing

• 404S Epoxy Metal Primer will be touch dry following 4 hours cure @ 20ºC in conditions of good ventilation
• Following 6 hours cure @ 20ºC the material may be re-coated
• Allow 7 days cure @20ºC for optimum chemical resistance and mechanical properties
• The primer may be allowed to age and weather for a maximum period of up to 3 months prior to top coating

Limitations

• Do not apply to wet surfaces
• Do not apply at temperatures of 5°C or less

Storage & Shelf Life

• Store in dry conditions, out of direct sunlight, at temperatures between 10°C and 25°C
• Avoid frost
• 404S Epoxy Metal Primer has a minimum shelf life of 12 months when stored in original, unopened containers in accordance with manufacturer’s instructions

Health & Safety

• Avoid contact of the material with skin and eyes
• Wear gloves and goggles
• Wash off splashes immediately with soap and water
• Any eye contamination must be rapidly irrigated with copious amounts of clean water, and immediate medical attention sought
• Please refer to Material Safety Data Sheet for additional information
• 404S Epoxy Metal Primer shall be applied strictly in accordance with the manufacturer’s instructions

For specific advice regarding any aspect of this product, please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]