A durable and long-lasting marking paint available in an assortment of rich and aesthetically-pleasing colours, for use on cycle lanes or pedestrian walkways. The eco-friendly solution allows for both internal and external use. Possible Uses Driveways. Pedestrian areas and walkways. Cycle routes and paths. Indoor flooring and walkways.
Rust-Oleum Tarmacoat is a water based, flexible acrylic exterior floor and tarmac paint that can be used on a multitude of surfaces.
- Rain-proof and recoatable after just one hour!
- Can be applied on slightly damp surfaces
- Excellent resistance to U.V. and weathering
- Water-based formulation, safe to use and virtually no odour
- Single pack, no mixing required
Rust-Oleum Tarmacoat is a very fast-drying multi-purpose single pack floor paint for exterior use as an overall floor coating or for line marking.
- Parking bays
- Tennis courts
Rust-Oleum Tarmacoat will cure sufficiently in approximately 24 hours to accept light traffic (bicycle, car, etc.), but allow 48 hours before bringing the area back into full use (heavy traffic; truck, heftruck,etc.).
Cold, damp or humid weather will delay curing. Apply by brush or medium pile type roller. Do not apply in areas which will be constantly under water.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
- Typical Coverage (per coat)
- 4m² per litre
- Touch Dry
- 30 mins
- Brush, Roller
|davy on 02/08/2018|| |
I have a balcony with cermaic tiles that are chipped and allowing water to pentetrate. Can I used this product direclty on tile and seal the balcony from further water damage?
No, but you could use Rust-Oleum Mathys Pegasol Quartz instead.
|Dāsi on 02/05/2018|| |
How do you apply the product? Can anyone do it or it requires an expert hand?
Please download the Product Data Sheet from the 'Download' section on the product page for details of how to apply.
|gillian vance on 19/04/2018|| |
I have small patio area 20ft by 10 ft roughly the yorkstone slabs surface is off almost. they have been down 20 years do you think if i could coated them with tarmac paint it would last ok?
We would recommend first priming with Rust-Oleum 5220 Epoxyshield Sealer assuming the surface will be porous. Then you could apply 2 coats of Rust-Oleum Tarmacoat.
|Robert Gordon on 24/02/2018|| |
Hi I have a imprinted drive way and was wondering if this paint would be suitable to cover it I have took the last coat of sealer of with a pressure washer and am now down to bare concrete thanks
Rust-Oleum Tarmacoat can be applied to exterior concrete surfaces but will not 'infill' or 'hide' the imprinted pattern the concrete has it will only colour it.
|Jeff on 01/11/2017|| |
Question: Can these colours be mixed to make different shades?
If you are asking two different colours of standard Tarmacoat can be mixed together to achieve a different colour, then yes that is possible. But the responsibility as to the actual colour achieved, and for any additional mixings to be consistent, is entirely with yourself.
|Bob on 25/11/2016|| |
Question: Is the anti slip aggregate ready mixed in or can extra be added and are two coats preferable
Rust-Oleum Tarmacoat is a smooth coating so if you wish to produce a non-slip surface you would need to use one of the Rust-Oleum Non-Skid Additives which can either be mixed into the Tarmacoat or sprinkled into the freshly applied coating and overcoated once dry.
307 Flexible Deck Coat is a solvent free, flexible resin coating modified to impart toughness, resilience and waterproofing properties. The abrasion and impact resistance, together with the low temperature flexibility and excellent adhesion to concrete, make 307 Flexible Deck Coat ideal for surfaces subjected to frequent vehicular traffic.
506 Anti Slip Dressing is sold in 10m² packs with each contain a flexible binding resin and decorative aggregate to create a 'stone carpet' finish which gives the appearance of loose aggregate, but avoids maintenance problems. Primarily used on outdoor walkways and concourse areas but can also be used internally to reflect the natural beauty of the outdoors.
Sikafloor 420 is a one part, elastic, low solvent containing, low odour, UV resistant, coloured, moisture triggered polyurethane resin coating. Used as a smooth or slip resistant, UV resistant, waterproof, abrasion resistant coating for concrete and cementitious screed substrates. For light to medium mechanical exposure on balconies, terraces,...
Rust-Oleum 5478 Asphalt Restorer makes old and faded asphalt and tarmac surfaces look like new again: 20% OFF THIS WEEK! Single application for driveways, car-parks and paths Provides an 'as new' appearance and avoids resurfacing costs Covers line markings and repair work Easy to apply Quick drying Rust-Oleum tarmac colour options...
This excellent slip-resistance paint has been specifically designed for the young budding Tim Henman's, with specific focus on enhancing youngsters' enjoyment of tennis. Advantages 3 Slip resistant rich colours. Matt finish. Water-based acrylic coating. Eco-friendly.
Ennis-Flint MMAXGrip PRMX 45 is designed as a versatile MMA coating for application to bituminous substrates, possesses excellent abrasion-resistance and non-skid properties and was developed specifically as a heavy-duty surfacing and can be applied to asphalt substrates without a primer. The product is used as a priming surfacer, a topping layer and...
Ennis-Flint Stonegrip is a specialist, hand applied surface treatment, consisting of a thermosetting, modified epoxy resin binder, dressed with a decorative aggregate. A wide range of aggregates are available comprising of different colours and sizes.
703 MMA Flexible Anti-Slip Coating is a fast curing, flexible coating for interior or exterior tarmac and asphalt surfaces enhanced by the incorporation of slip resistant aggregates premixed into the resin.
Blackfriar Professional Acrylic Floor Paint is a quick drying, low odour water based floor paint providing a tough and durable finish on virtually any surface including wood, concrete, asphalt and tarmac in light traffic areas. Blackfriar Professional Acrylic Floor Paint resists grease, oil and weak solutions of acid and alkali, making it ideal for...
Ennis-Flint MMAXGRIP PRMX 65 is a MMA-based coating that was developed specifically for application to public main roads and side streets as well as other traffic zones. Its special properties make MMAXGRIP PRMX 65 particularly suitable for surfaces where coloured road markings are required on main roads and side streets in urban areas and elsewhere.
As we're sure you'll agree, playgrounds must be safe, fun, colourful and eco-friendly. This specially-formulated paint is designed for use on tarmac and concrete playground surfaces, and comes in a range of terrific colour shades. Advantages 10 fun colour shades + black and white. Water-based. Matt finish.
Sikafloor 405 is a one part, pigmented, highly elastic, solvent containing, UV resistant, moisture triggered curing polyurethane resin coating. Sikafloor 405 is a slip resistant, waterproof, crack-bridging coating for concrete, cementitious screed substrates and tiles.