Watco Asphalt & Concrete Resurfacer is a water based acrylic coating that seals and resurfaces damaged and worn asphalt. Easily applied by roller, it forms a flexible, sealed, waterproof surface that transforms old asphalt, concrete, and tarmac. It provides a tough flexible surface for cars and pedestrians.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Surface Preparation
• Mixing
• Application

Features & Benefits

• Areas of use include:
• Car parks
• Playgrounds
• Driveway
• Single pack, easily roller applied
• Non-hazardous and low odour acrylic formula
• Excellent adhesion and covering power
• Quick drying (24 hours for light traffic)
• Excellent resistance to UV and weathering
• Can be applied up to a maximum depth of 1mm in one application. Multiple coats can be applied for badly worn patches
• Suitable for pedestrian and light-medium traffic (cars, not HGV’s or forklifts)
• Do not apply too thickly in one application. This can cause a delay in the drying process and may lead to cracking.
• Produces a tough, flexible layer. However, if applied over a crack (when the crack has been caused by movement) it may crack if significant movement re-occurs. The product is sufficiently flexible to tolerate the usual expansion and contraction associated with asphalt.
• Will seal the substrate and as such could add to puddling on poorly drained areas during wet weather. Apply only in dry, warm (above 10°C) conditions when rain is not forecast.

Surface Preparation

Ensure surfaces are clean, dry and free of loose material. If the surface has been previously painted, remove as much paint as possible by mechanical means. Any remaining paint should be well bonded and lightly abraded to provide a key.

Watco Bio-D, a bio-degradable water based degreasant can be used for grease removal from concrete and asphalt.

Mixing

Stir the contents well with a wide bladed mixing tool to ensure that the product has not settled in transit.

Application

Apply only in dry conditions (above 10°C and below 35°C). Do not apply in cold, damp conditions or when rain is forecast.

In warmer conditions 25°C - 35°C dry, hot surfaces should be slightly dampened first.

Pour onto the surface in ribbons and spread it out with a medium pile roller.

Apply thinly. The second coat can be applied as soon as the first coat has dried. Further thin multiple coats can be applied for badly worn areas.

Important – Do not apply the product in layers thicker than 1 mm. Never add water to the product.