• Touch dry after 4 hours at 20°C.
• Through dry after 8 hours at 20°C.
• Recommended over coating after 12-18 hours.
• Light Traffic after 12-24 hours.
• Forklifts/Heavy Traffic after 48 hours.
• Avoid washing surface until a full cure has been completed after 7 days.

Preparation

New Concrete Floors:

• New Concrete must be at least 4 weeks old before considering coating the substrate or moisture less than 5%
• The surface must be clean, sound, dry and fully cured and surface latience removed preferably by enclosed shot blasting or mechanical grinding.

Existing Concrete Floors:

• Remove all dirt, oil, grease or other surface contaminants by enclosed shot blasting, scarification or mechanical grinding.
• Fats ,oils or greases must be removed by mechanical means and detergent washing.

Mixing:

• Add the smaller tin containing PART B - CURING AGENT to the bigger tin containing PART A - EPOXY RESIN. Ensure mixing of the combined materials is done thoroughly using a spatula, wide bladed tool and or drill assisted paint mixing tool (on its lowest speed setting).
• Always ensure a spatula is used to mix any unmixed materials from the sides or the bottom of the tin.
• It is suggested that continuous mixing is maintained for at least 3 minutes until an even colour and uniform consistency is achieved. Over mixing must be avoided to reduce air entrainment.
• Do not mix more than one pack at a time.

Pot Life:

• Up to 45 minutes at 20°C. Greater temperatures will reduce pot life.

Application

• Stir well before use.
• Please follow the coverage rates shown in Spreading Rate Section.
• Store between 15°C - 25°C for at least 8 hours before use.
• The ambient temperatures of the areas should not be allowed to fall below 10°C throughout the application and curing period.
• Surface temperatures must be above 5°C, in cases where the temperature is higher than 30°C, the surface should be dampened with water.
• Apply by brush or short-medium pile solvent resistant roller ensuring the product is well worked into the surface.
• Do not use a water-based roller
• Do not exceed the coverage rates stated above.
• Do not over roll.
• Floor areas should be cross-rolled to ensure even application and to minimise roller marks.
• Second coat can be applied after 12-18 hours and should be completed within 5 days of initial coat, if left for longer than 5 days, the surface should be abraded pre second coat.

Cleaning

• Before the product cures all applicators should be washed in warm soapy water. Any spillages of the PART A - EPOXY RESIN prior to mixing must be removed by solvents.

Shelf Life & Storage

• Do not allow packs to freeze.
• 12 months shelf life from date of production in original unopened containers and can be stored in dry conditions between 5°C - 30°C.

Precautions

• See Safety Data Sheets. Part A - Part B
• Wear gloves, goggles and suitable protective clothes.
• In case of contact with eyes rinse immediately with plenty of water and seek medical advice.
• Remove splashes from the skin with a recognised hand cleaner or plenty of soap and water.
• Keep out of reach of children.
• Do not use near fishponds.
• Toxic to aquatic organisms. May cause long term adverse effects in the aquatic environments.
• Do not empty into drains.