Rust-Oleum 8700 Mould Resistant Hygiene Acrylic Topcoat
  • Rust-Oleum 8700 Mould Resistant Hygiene Acrylic Topcoat

Rust-Oleum 8700 Hygienic Acrylic Topcoat

8792.5

Rust-Oleum 8700 Hygienic Acrylic Topcoat is a water-based single pack hygienic topcoat designed and developed by Rust-Oleum which protects walls and ceilings against normal humidity and contamination indoors.

  • Offers better protection against contamination than non-hygienic paint
  • Very fast drying and recoating times (3 coats in a day)
  • Water-based paint
  • Can be applied on damp surfaces in combination with Rust-Oleum 8798 Hygienic Acrylic Primer
  • Durable gloss finish
Colour
Size
Finish
£99.86
VAT excluded

£119.83 Tax incl.
Quantity

Description

Rust-Oleum 8700 Hygienic Acrylic Topcoat

Rust-Oleum 8700 Hygienic Acrylic Topcoat is a water-based single pack hygienic topcoat which protects walls and ceilings against normal humidity and contamination indoors.

Features & Benefits

  • Offers better protection against contamination than non-hygienic paint
  • Very fast drying and recoating times (3 coats in a day)
  • Water-based paint
  • Can be applied on damp surfaces in combination with Rust-Oleum 8798 Hygienic Acrylic Primer
  • Durable gloss finish

Technical Data

  • Density: 1,2
  • Gloss Level: Gloss
  • Solids content in volume: 35 %
  • Heat Resistance: 80°C (dry heat)

Drying Times At 20°C/RH 50%

  • Touch dry: 30 minutes (20°C), 2 hours (10°C), 15 minutes (30°C)
  • Dry to handle: 2 hours (20°C), 6 hours (10°C), 2 hours (30°C)
  • Dry to recoat: 2 hours (20°C), 16 hours (10°C), 2 hours (30°C)
  • Fully cured: 3 days (20°C), 5 days (10°C), 2 days (30°C)

Theoretical Consumption

10 m²/l

Practical Consumption

Practical coverage depends on many factors such as porosity and roughness of the substrate and material losses during application.

Surface Preparation

Remove grease, oil and all other surface contaminations by alkaline or high pressure (steam) cleaning in combination with appropriate detergents. Remove contamination with FK111 or ND14. Wash total surface with plenty of fresh/warm water or high pressure (steam) cleaning in order to remove all remnants of contamination and cleaners. Prime or spot-prime with White Masonry Sealer 8798. Sand intact coatings to roughen the surface slightly. The surface must be clean and may be slightly damp during application.

Remarks

Maximum dry film thickness per coat: 80 µm dry, equals 225 µm wet. On very porous
substrates it is advisable to dilute the first coat up to 50% with water, followed by a second
coat.

Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information.

It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.

Product Details
8792.5

Data sheet

Application
Brush, Roller, Spray
Dry to Handle (at 20°C)
2 Hours
Dry to Recoat (at 20°C)
2 Hours
Fully Cured (at 20°C)
3 Days
Coverage
10m² per litre
Max. Application Temperature
35°C
Min. Application Temperature
5°C
Density
1,2
Solids by Volume
35 %
Heat Resistance (up-to)
80°C (dry heat)
VOC
87 g/l
Touch Dry
30 mins
Recommended Dry Film Thickness
35 µm
Recommended Wet Film Thickness
100 µm
UN Number
Not regulated
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.


questions John adair  on 08/05/2018
Question: 

I'm repainting 500m² of cladding inside ameat processing factory its got a foodsafe laminate coating which has discoloured from smoke damage it's only 3months old factory I will do with airless spray its white an walls an ceiling I need to put on the best foodsafe coating u can supply help with your knowledge asap Greatly Appreciated Jregards John

Answer: 

Rust-Oleum 8700 Hygienic Acrylic Topcoat is used regularly in such environments so in that respect may be considered “foodsafe”, although it has never been submitted for any test. By itself it could not be offered as blocking the fire damage stains. In which case we should consider using something like the Mathys Pegaprim Isofix first.


Question about the product

* Required fields
(read)
Send
You might also like

Rust-Oleum FK111 Cleaning Solution

Rust-Oleum FK111 Cleaning Solution is a concentrated, alkaline, non-flammable, virtually odour free cleaning and degreasing solution for vertical substrates like walls. High-viscosity formulation is ideal for use on walls, does not run off the wall Removes grease, oil, proteins , dirt and many other contaminants Usable as additive for...

Price £37.43
In stock

Rust-Oleum 8798 Hygienic Acrylic Primer

Rust-Oleum 8798 Hygienic Acrylic Primer is a water-based single pack hygienic primer which once overcoated with Rust-Oleum 8700 Hygienic Topcoat protects walls and ceilings against normal humidity and contamination indoors. Fast drying and recoatable with Rust-Oleum 8700 Hygienic Topcoat Offers better protection against contamination than...

Price £89.95
In stock

Rust-Oleum Mathys ND14 Cleaner Degreaser

Rust-Oleum Mathys Alkaline Cleaner/Degreaser ND14 should be used to remove grease, oil, proteins, dirt and many other surface contaminants from coated, mineral and steel substrates. Concentrated formulation can be diluted 1:20 Use as additive for high pressure cleaning Non-flammable, virtually odour-free

Price £62.28
In stock
16 other products in the same category:

Sikagard 206 W (Sterimatt)

Sikagard 206 W (Sterimatt) has been discontinued by the manufacturer and has been replaced with Sikagard 406 W. Should you require any further information or advice on this change, please contact our Technical Department on 0113 2455450 or [email protected]

In stock

SikaProof A Membrane Edges

SikaProof A Edge is a preformed L-shaped SikaProof A membrane sheet in 1m width folded in 50/50cm with a self-adhesive strip on both sides for a faster and easier application of perimeter edges, corners and connections. Used for damp-proofing, concrete protection and waterproofing for basements and other below ground concrete structures...

Price £811.27
In stock

Rust-Oleum Biosan Aqua Matt

Rust-Oleum Biosan Aqua Matt is ideal for walls and ceilings where hygiene control is essential in low wear areas. Offers high durability, perfect saponification resistance, particularly high covering capacity and helps to maintain a hygienic environment. Decorative hygienic paint in gloss, satin or mat in almost any colour Good flow,...

Price £51.53
In stock

Zanders PF59 Stain Blocking Primer Finish

Zanders PF59 Stain Blocking Primer Finish is a high quality primer finish in a durable matt finish for all interior and exterior wood, plaster and masonry. Based on advanced acrylic technology Zanders PF59 Stain Blocking Primer Finish also inhibits stains bleeding through the substrate. Features and Benefits Matt finish excellent opacity...

Price £93.98
In stock

Coo-Var Profloor Plus Cold Cure

Coo-Var Profloor Plus Cold Cure is a low temperature curing version of Coo-Var Profloor Plus. This two-pack, solvent free epoxy resin coating is designed to cure when the surface temperature is in the range 0 to 10°C. Coo-Var Profloor Plus Cold Cure is particularly valuable for applications at colder times of the year when the cure time of the...

Price £115.97
In stock

Sikagard 205 W (Sterisheen)

Sikagard 205 W (Sterisheen) has been discontinued by the manufacturer and has been replaced with Sikagard 405 W. Should you require any further information or advice on this change, please contact our Technical Department on 0113 2455450 or [email protected]

In stock

SikaProof A Membranes

SikaProof A05, SikaProof A08 and SikaProof A12 are fully and permanently bonded, self-adhesive, composite sheet membrane waterproofing systems for reinforced concrete of the main structure. It consists of an embossed polyolefin (FPO) membrane laminated with a sealant grid and a non-woven fleece. Damp-proofing, concrete protection and waterproofing for...

Price £585.06
In stock

Coo-Var Guard-Coat

Coo-Var Guard-Coat is an anti-microbial coating which inhibits the growth of bacteria. The antibacterial action is created with silver ion technology. This exceptionally hard wearing epoxy paint system is suitable for floors and walls (even with heavy foot and vehicle traffic). Dries to an off-gloss finish. Water thinnable. Coo-Var Guard-Coat...

Price £96.53
In stock

Sikagard 406 W

Sikagard 406 W is a single component white, waterborne acrylic resin based surface coating containing an organic in film preservative with a mat finish.  Topcoat or standalone coating for: internal walls and ceilings for concrete, bricks, cement based and gypsum substrates, metallic surfaces, timber, tiles and plastic. Suitable for...

Price £86.75
In stock

Sika Standard Drainage Membrane

The Sika Standard Drainage Membrane is an 8mm polypropylene studded membrane used for internal fixing to masonry, stone or concrete walls, dry lined walls, and as a floor membrane where limited water passage is anticipated. Provides a fast track waterproofing solution for walls or floors, suitable for use above and below ground, impermeable...

Price £365.21
In stock

Sika Plaster Drainage Membrane

The Sika Plaster Drainage Membrane is a 5mm high-density polyethylene cavity drainage studded membrane used for internal fixing to masonry, stone or concrete walls.  Suitable for over-plastering/rendering with sand/cement or with Sika Whitewall one coat anhydrite plaster.  Features and Benefits Easy to cut, fix and seal Unique undercut...

Price £365.21
In stock

Remmers Crete TF

Remmers Crete TF is a solvent-free coating based upon polyurethane technology which provides excellent resistance to abrasion, chemical attack and other physical aggression. Used in areas requiring good wear and chemical resistance Economical cost It is suitable for chemical storage areas; Warehousing Toilets Laboratories Food...

Price £27.90
In stock

Sika Drain 850 Geo

Sika Drain 850 Geo is a heavy duty drainage and protection sheet used as a protection and drainage sheet for preformed sheet membrane waterproofing systems, liquid applied membranes and with the Sika White Box concept for waterproofing retaining walls and heavy duty roofs/podiums. Features and Benefits High drainage capacity High...

Price £2,575.08
In stock

Coo-Var Shellac Prime-All

Coo-Var Shellac Prime-All is a heavy duty, shellac based coating designed to block out difficult stains and odours. Ideal for sealing tar, bitumen and creosoted surfaces and to prevent bleeding through in subsequently applied solvent based paints. It exhibits heavy stain blocking from nicotine, pen, oils and water stains and has rapid drying...

Price £21.12
In stock

Rust-Oleum 8399 Hygienic Primer

Rust-Oleum 8399 Hygienic Primer is a specially formulated hygienic primer for use with Rust-Oleum 8300 Hygienic Topcoat. As a system it protects against mild chemical exposure, occasional product spillage, frequent chemical cleaning, humidity and moisture. Ideal for walls and ceilings. Very fast drying and recoatable with Rust-Oleum 8300...

Price £72.23
In stock

Rust-Oleum 9700 Coldmax Rapid (Wintergrade)

Rust-Oleum’s strongest coating ever, based on the latest rapid curing polyaspartic technology for inside or outside use. This makes Rust-Oleum 9700 Coldmax Rapid (Wintergrade) ideal when extra protection against traffic and chemicals is needed. This versatile coating can also be used outdoors and in cold rooms and freezers. Overcoatable...

Price £60.09
In stock