This product is temporarily unavailable; in the meantime, our technical team recommend Glixtone Fungi-Shield Anti-Mould & Black Spot Paint Matt as a great alternative - use discount code SAVE10 at checkout to save 10%!
Please note: it is important to check that any alternative product is suitable for your requirements, as our suggestion is given in good faith but without warranty. If you are in any doubt please first contact our technical team on 0113 2455450 (option 2) or send a message to [email protected] where we will be happy to discuss your project.
Blackfriar Fungi-Shield is a washable, biocidal paint for use against algae, mould and fungi on internal surfaces such as bathroom and kitchen walls and ceilings.
- Quick drying.
- Interior use.
- For areas of high humidity.
- Totally resistant to mould growth.
- Matt finish.
Blackfriar Fungi-Shield is a washable, decorative fungicidal anti-mould finish for use in areas susceptible to mould and bacterial growth. For internal use on any above ground surface to eliminate mould, algae and fungus.
Remove grease, dirt, mould, rust and allloose and flaking material. Treat all areas affected by organic growth with Fungicidal Wash. Repair surfaces to asmooth finish. Treat bare areas with Blackfriar Quick Drying Primer Undercoat. Tape exposed copper pipe.
Apply two coats by brush, roller or spray. First coat may be thinned with water for absorbent substrates. Remove any splashes from adjacent trim if to be painted by conventional gloss.
Do not use under cold (less than 10°C), damp or humid conditions.
Touch dry in 1 - 2 hours. Recoat after 4 hours.
Remove as much product as possible from application equipment before washing with water. Do not empty into drains or water courses. Some local authorities have special facilities for the disposal of waste coatings. Statutory conditions relating to use - for use only as a surface biocide.
Wear suitable protective clothing and gloves.
DO NOT CONTAMINATE FOODSTUFFS, EATING UTENSILS OR FOOD CONTACT SURFACES. COVER ALL WATER STORAGE TANKS BEFORE APPLICATION. THIS MATERIAL AND ITS CONTAINER MUST BE DISPOSED OF IN A SAFE WAY. UNPROTECTED PERSONS AND ANIMALS SHOULD BE KEPT AWAY FROM TREATED AREAS FOR 48 HOURS OR UNTIL SURFACES ARE DRY. FOR INDOOR USE ONLY. THIS PRODUCT CONTAINS SUBSTANCES WHICH ARE KNOWN TO BE HAZARDOUS TO THE ENVIRONMENT. DO NOT CONTAMINATE GROUND, WATERBODIES OR WATERCOURSES WITH CHEMICALS OR USED CONTAINER.
READ ALL PRECAUTIONS BEFORE USE. HSE 7868. THIS PRODUCT CONTAINS AN ANTICHOLINESTERASE CARBAMATE COMPOUND. DO NOT USE IF UNDER MEDICAL ADVICE NOT TO WORK WITH SUCH COMPOUNDS. WASH ANY CONTAMINATION FROM SKIN OR EYES IMMEDIATELY. WASH HANDS AND EXPOSED SKIN BEFORE MEALS AND AFTER USE. KEEP ONLY IN THE ORIGINAL CONTAINER. KEEP IN A SAFE PLACE.
This product is approved under the Control of Pesticides Regulations 1986 (as amended) for use as directed. HSE No. 7868.
- For areas of high humidity
- Matt finish
- For interior use
Please contact Rawlins Paints' Technical Support Team on 0113 2455450 for more information
- Blackfriar Professional
- Interior / Exterior Use
- Water / Solvent Based
- Application Method
- Brush, Roller
- Standard / Ready Mixed
- VOC Levels
- Low (50-149 g/l)
- Single, Two or Three Pack
- Pack Size
- 2L, 2.5L
- Base Type
- Water Based
- Interior/Exterior Use
- Brush, Roller
- Dry to Recoat (at 20°C)
- 4 hours
- 11-13m² per litre
- Touch Dry
- 1-2 Hours
- UN Number
|steve mattinson on 2019-10-22 16:53:17|| |
Hi. Can the Blackfriars anti-fungal paint have a colour mixed into it or does it come in white only?
|Chaz on 2019-01-14 00:17:48|| |
Hi can the Blackfriar fungi shield paint be used under lining paper that is to be painted in normal coloured emulsion paint? If not which product would be best for this? My walls aren't damp at all but I've had mould under my wall paper thanks
Treating the mould with a suitable mould killer is advisable. The Blackfriar Anti-Mould Solution is a suitable product.
Treat areas of mould thoroughly and leave overnight to get the most out of it. In severe mould cases 2-3 treatments of the Anti-Mould Solution can be given washing off between applications. The final application can be left on the surface then wallpaper applied over the top. The residue of the Anti-Mould Solution should prevent mould from growing back. There would be no need to apply Blackfriar Fungi-Shield as an additional layer.
|Ryan payton on 2018-10-28 17:20:25|| |
Which damp proofing paint is best to use on plastered walls that have already been painted with emulsion...
We would recommend Coo-Var Anti-Damp Paint.
|Diana on 2018-03-06 00:37:56|| |
Hello! What anti-mould paint can I use for wood like the back of chest of drawers? Thank you!
This product is temporarily unavailable; in the meantime, our technical team recommend Coo-Var Acrylic Primer Sealer Undercoat as a great alternative - use discount code SAVE10 at checkout to save 10%! Please note: it is important to check that any alternative product is suitable for your requirements, as our suggestion is given in good faith...
General Painting Application Kit from Rawlins Paints provides the basics for any painting project. Whether it is a one off job, or you just want to make sure the right application tools get to site. Provides an economical way of making sure you will have what you need Ideal for interior and exterior paint projects Click to jump down to...