Zanders PF59 Stain Blocking Primer Finish
Zanders PF59 Stain Blocking Primer Finish is a high quality primer finish in a durable matt finish for all interior and exterior wood, plaster and masonry. Based on advanced acrylic technology Zanders PF59 Stain Blocking Primer Finish also inhibits stains bleeding through the substrate.
- Excellent opacity - Low odour - Stain-blocking properties
- Excellent adhesion - Interior and exterior use
- Please Note: Suitable for use as a Primer and Finish for interior use but as a Primer only for exterior use
- 1300+ colours in RAL, NCS and British Standard shades
**Available for delivery - see Delivery Options below**
Product customisationDon't forget to save your customization to be able to add to cart
Zanders PF59 Stain Blocking Primer Finish is a high quality primer finish in a durable matt finish for all interior and exterior wood, plaster and masonry. Based on advanced acrylic technology Zanders PF59 Stain Blocking Primer Finish also inhibits stains bleeding through the substrate. 1300+ colours in RAL, NCS and British Standard shades.
Please Note: Suitable for use as a Primer and Finish for interior use but as a Primer only for exterior use.
Ensure all surfaces to be painted are clean, dry and free from grease and loose or flaking material, or any other contaminants that may impair adhesion. Any faults in the substrate, particularly those that can lead to moisture penetration must be rectified or can affect the finish quality. Any existing crazes or flaking paint, dirt, grease or other surface contaminants should be removed. If your substrate has been previously painted, rub down with a fine waterproof abrasive paper and then rinse thoroughly. Bare substrates should also be abraded in a similar manner to allow improved adhesion. Please avoid inhaling any sanding dust and always wear a face mask if fine sanding. Special precautions should be taken during preparation of pre-1960's paint surfaces over wood and metal as they may contain harmful lead.
Hard wall plasters should be scored with a coarse glass-paper. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding.
Stir the product thoroughly to ensure it is fully homogenous, do not contaminate. For best results apply by brush, roller or spray. Application tool type and quality may influence the finished appearance. Apply liberally and avoid overspreading. Not to be applied below 8°C. Under normal conditions Zanders PF59 Stain Blocking Primer Finish will be touch dry after 1 hour, and additional coats can be applied after 3-4 hours. Ensure good ventilation during drying and application.
Porous surfaces should be sealed with a first coat of Zanders PF59 Stain Blocking Primer Finish thinned with up to 20% clean water. Allow fresh plaster to dry thoroughly before application.
It is recommended that the application of 2 coats is generally sufficient, though more may be required dependant on the nature and porosity of the substrate.
- Interior / Exterior Use
- Interior and Exterior
- For Use On
- Plaster, Masonry, Wood
- Application Method
- Brush, Roller, Spray
- Standard / Ready Mixed
- Single, Two or Three Pack
- Pack Size
- Brush, Roller, Spray
- Touch Dry (at 20°C)
- 1 Hour
- Dry to Recoat (at 20°C)
- 2-4 Hours
- Fully Cured (at 20°C)
- 7-10 Days
- 9m² per litre
Be the first to ask a question about this product!