Jotun Penguard Pro GF
A glass flake reinforced, abrasion resistant epoxy coating that is surface tolerant, fast drying, high solids and high build. Specially designed for areas where increased abrasion and impact resistance is needed such as decks, walkways and landing areas.
Jotun Penguard Pro GF is a two component amine cured, glass flake reinforced, abrasion resistant epoxy coating that is surface tolerant, fast drying, high solids and high build. Specially designed as a universal, all round, all year, new construction coating where fast dry to handle times are required. It can be used as a primer, mid coat, finish coat or as a single coat system in atmospheric and immersed environments. Suitable for properly prepared carbon steel, stainless steel, aluminium, galvanised steel and thermally sprayed zinc substrates. It can be applied at sub zero surface temperatures.
Jotun Penguard Pro GF is suitable for structural steel and piping to be exposed to corrosive environments up to very high and immersed. Recommended for offshore environments, including splash zones, refineries, power plants, bridges, buildings and mining equipment. Specially designed as a universal product in coating systems where extended durabilty is required. The product provides flexibilty in a choice of dry film thicknesses as well as area of use and application temperatures. Designed for areas where increased abrasion and impact resistance is needed such as decks, walkways and landing areas.
Approvals and certificates
- Highways Agency Approved - Item No. 123
- Pre-qualification testing in acordance with NORSOK M-501, Rev. 5, System 1, suitable for exterior exposure in offshore environment, below 120 °C.
- Pre-qualification testing in acordance with NORSOK M-501, Rev. 5, System 7, suitable for splash zones.
Additional certificates and approvals may be available on request.
It is your responsibility to read the Product Data Sheets (available below) before you place an order and prior to application of the product. The content of this website is our best recommendation and is not advice. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. We ALWAYS recommend a trial area is coated to ensure the product meets your requirements before use.
|Typical Coverage (per coat)||3m² per litre|
|Touch Dry||3 hours|
|The figures stated above are approximate. Please ensure you refer to all datasheets for full application information.|
Be the first to ask a question about this product!
Colour reproduction of the Products on the Site is limited by the technology used to deliver web pages and by the colour representation of Customer’s own monitor and computer set-up. We have made every effort to display as accurately as possible the colours of our Products but we cannot guarantee that the colour shown on Customer’s monitor’s display will accurately reflect the colour of the Product on delivery. We recommend that Customer first purchases the smallest Product available or access an industry standard colour chart in person (and not digitally) to ensure that the colour is acceptable for its purposes. For more information, please see our Terms & Conditions of Sale.Close