Carboline CARBO-KIT Carbothane 133 HG is a two-component, high build, glossy finish that has outstanding weathering resistance and colour retention. Suitable for application over several Carboline primers and intermediates, this material provides excellent corrosion resistance in a broad range of colours.

This coating is designed for brush and roller application for maintenance and is used when there are high requirements for corrosion protection.

Click To Jump To Section:

• Features and Benefits
• Product Specification
• Drying Times
• Surface Preparation
• Application Methods
• Application Conditions
• Health and Safety

Features and Benefits

• Two-component aliphatic polyurethane.
• Extremely suitable for use in chemical industry, offshore, hydropower and other heavy industry
• Gloss finish
• Available in 400+ RAL and BS colours

Product Specification

Drying Times

• These times are based on 50 - 100 microns dry film thickness. Higher film thickness, insufficient ventilation or cooler temperatures will require longer cure times and could result in solvent entrapment and premature failure.

Surface Preparation

General

• Surface must be clean and dry.
• Employ adequate methods to remove dirt, dust, oil, and all other contaminants that could interfere with adhesion of the coating.

Steel

• Prime with specific Carboline primers as recommended by Rawlins on Tech - 0113 2455450 (option 2) or [email protected] Sales - 0113 2455450 or [email protected]
• Refer to the specific primer’s product data sheet for substrate preparation requirements.

Concrete

• Apply over clean and dry concrete or recommended primer.
• All concrete should dry/cure for minimum 28 days at 20°C and 50% relative humidity or correspondingly, prior to application of paint.

Aluminium

• SSPC-SP1 (“Solvent Cleaning”) and prime with appropriate Carboline primer as recommended by Rawlins.

Previously Painted Surfaces

• Lightly sand or abrade to roughen and de-gloss the surface. Existing paint must attain a minimum 3B rating in accordance with ASTM D3359 “XScribe” adhesion test. Prime with specific primers as recommended by Rawlins.

Application Methods

Application Conditions

• Industry standards are for substrate temperatures to be 3°C above the dew point.
• Special application techniques may be required above or below normal application conditions.

Health and Safety

Clean Up

• Use Thinner 2 or Acetone
• In case of spillage, absorb and dispose of in accordance with local applicable regulations.

Safety

• Read and follow all caution statements on this product data sheet and on the safety data sheet for this product.
• Employ normal workmanlike safety precautions.
• Hypersensitive persons should wear protective clothing, gloves and use protective cream on face, hands, and all exposed areas.

Ventilation

• When used as a tank lining or in enclosed areas, thorough air circulation must be used during and after application until the coating is cured.
• The ventilation system should be capable of preventing the solvent vapor concentration from reaching the lower explosion limit for the solvents used.

Caution

• This product contains flammable solvents. Keep away from sparks and open flames.
• All electrical equipment and installations should be made and grounded in accordance with the applicable local regulations.
• In areas where explosion hazards exist, workmen should be required to use non-ferrous tools and wear conductive and non-sparking shoes.

• Refer to the product and safety data sheet in the attachments section above for further details.