Teamac Metalastic Metal Protective Paint Colours is a high quality, high build, general purpose gloss paint for use on a wide range of suitably prepared surfaces such as wood, metal, asbestos, stable felt, etc. Available in a wide range of colours.
Ideal for protecting and decorating metal, wood and many other surfaces inside or outside. Frequently used in factories, warehouses, farm buildings, roofs, barns, oil tanks and general steelwork are amongst the possible applications.
Click To Jump To Section:
Features & Benefits
Advantages
Product Specification
Technical Data |
Volume Solids |
43 to 50% |
VOC Content |
499 Max g/litre |
SG |
0.92 to 1.15 @ 20°C |
Viscostity |
4.0 Poise @ 25°C |
Flash Point |
Above 32°C (closed cup) |
Film Thickness Range And Coverage
Product Data |
|
Dry Film Thickness |
Wet Film Thickness |
Theoretical Coverage |
Maximum |
30 to 35 µm |
70 µm |
14 m2/litre at 30 to 35 microns D.F.T |
The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application. |
Drying Times
Drying Times At 20°C/RH 50% |
Touch Dry: |
4 Hour |
Dry To Recoat: |
12 hours or overnight |
Fully Cured: |
3 - 5 Days |
Low temperature and high humidity will adversely affect application, drying and performance of any coating.
Surface Preparation
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates. Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed as hand cleaning does not clean the steel to the required degree. Any oil or grease should be removed with Teamac Universal Degreaser before de-rusting. Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts, welds etc. Welds should, if necessary be ground and all weld spatter, slag etc. must be removed. Existing painted surfaces - Surfaces should be cleaned, degreased and sanded to ensure an adequate "key" is produced. Remove all loose and flaking material and treat bare areas as new substrate and prepare accordingly.
Preceeding Coat
Mixing
Stir well before use.
Application Conditions
As dictated by normal good painting practice. Care must be taken during application that the temperature is above the dew point to avoid any contamination. In confined spaces, provide adequate ventilation during application and drying.
Application Methods
Method |
Airless Spray |
Conventional Spray |
Brush |
Roller |
|
Yes |
No |
Yes |
Yes |
- Thinner (Max vol): Thinners 14
- Nozzle Size: 0.015"
- Nozzle Pressure: 21800 to 2000 psi
Health & Safety
See safety data sheet - All colours - SDS 10647, Aluminium - SDS 10671
Click to go back to the top of the page