Teamac QD Zinc Phosphate Primer is a high build, high performance quick drying metal primer. It has excellent anti-corrosive properties.
Used as an anti-corrosive primer on iron and steel where rapid coating and finishing is required. Ideal in coastal areas.
Quick Links - Click To Jump To Section:
Features & Benefits
- High build
- High performance
- Quick drying
- Excellent anti-corrosive properties
- Used as an anti-corrosive primer on iron and steel where rapid coating and finishing is required
- Ideal in coastal areas
Product Data
Product Data |
Typical S.G. (Specific Gravity) |
1.5 @ 20 °C |
Volume Solids |
56% |
Wet Film Thickness W.F.T |
100 to 135 microns |
Dry Film Thickness D.F.T |
50 to 75 microns |
Expected Spreading Rate |
10 sq.m / litre @ 50 microns DFT |
7.5 sq.m / litre @ 75 microns DFT |
The practical spreading rate may be lower as this depends on factors such as the porosity and roughness of the surface to be painted and material losses during application. |
Typical Viscosity |
2.2 to 2.5 Poise - C&P @ 25 °C |
Flash Point |
25 °C (closed cup) |
Voc Content |
382 / litre |
Drying Times
Drying Time @ Recommended D.F.T |
Touch Dry |
15 to 30 mins @ 20 °C |
Hard Dry |
6 hours @ 20 °C |
Full Hardness |
N/A |
Low temperature and high humidity will adversely affect application, drying and performance of any coating. |
Minimum Overcoating Time |
4 hours |
Application Details
Application Details |
Method |
Airless Spray |
Thinner(Max vol) |
Thinners 16 (10%) |
Nozzle size |
0.017" - 0.021" |
Nozzle pressure |
1800 to 2000 psi |
Cleaning solvent |
Thinners 16 |
Recoat interval |
4 hours |
Surface Preparation
Ensure all surfaces are clean, dry and free from grease, oil and any other contaminates.
Bare steel should be free from dust, rust and scale. Blast cleaning to SA 2½ is recommended. If blast cleaning is impractical, mechanical cleaning should be employed as hand cleaning does not clean the steel to the required degree.
Any oil or grease should be removed with Teamac Universal Degreaser before de-rusting.
Where blast cleaning is carried out after assembly, special attention must be paid to edges, corners, nuts, bolts, welds etc. Welds should, if necessary be ground and all weld spatter, slag etc. must be removed.
Mixing Instructions
Mix well before use.
Application Conditions
As dictated by normal good painting practice. Care must be taken during application that the temperature is above the dew point to avoid any contamination. In confined spaces, provide adequate ventilation during application and drying.
Preceding Coat
N/A
Subsequent Coat
Suitable topcoat, e.g Teamac Rapidry Gloss.