We no longer stock this product; please contact our technical team on 0113 2455450 (option 2) or send a message to [email protected] where we will be happy to find an alternative product. See our Metal Paints page for more Primers and Undercoats.
Torlife ST Primer is a high-performance coating for priming previously painted and non-convertible coatings (eg. pliolite or chlorinated rubber) prior to application of Torlife TP anti-graffiti coatings. A two pack pigmented epoxy/polyamide containing aromatic hydrocarbon and alcohol solvents.
Refer below for more product information, preparation and application instructions
Product Information
A two-pack pigmented epoxy/polyamide containing aromatic hydrocarbon and alcohol solvents.
Product reference
EP146
Volume solids
80%
Typical thickness
80 microns dft from 100 microns wft
Theoretical coverage
10 square metres per litre
Practical coverage
Reduce above by up to 20%
Appearance
Matt / White
VOC content
218 grams/litre
Surface Preparation
Scrape off any loose or flaking paint back to a firm edge.
Wash down using Torstrip WDA 10 wash down agent diluted 1:10 parts with water. Rinse with clean water.
Remove any existing graffiti with Torclean Graffiti Wipe System or Torclean “G” Graffiti Remover.
Feather off and repair any damaged surfaces with a high-quality filler.
Ensure the surface is clean, dry and free of any surface contamination prior to paint application.
Application Details
Mix ratio
Base and activator supplied in correct proportions. Add all activator to base container. Mix thoroughly for at least 5 mins until product is smooth and even. Allow to rest 5 mins before using. DO NOT MIX PART UNITS. Badly activated or incorrectly mixed materials will affect performance and may cause early failure or discolouration.
Method of application
Apply 1 coat by brush or short/medium pile roller
Thinner
Not recommended
Cleaner
Tor TH98 for cleaning equipment
Pot Life
4 hours
Drying Times
Substrate Temperature
Touch Dry
Hard Dry
Overcoating Interval
Minimum
Maximum
20°C
8 hours
48 hours
24 hours
5 days
Note: Drying/curing times will be shortened by higher temperatures and lengthened by lower temperatures
Storage and Handling
Store in a safe place out of the reach of children
Flash point
23°C
Shelf life
2 years in unopened containers
Limitations
Below 10°C cure times will be significantly extended
The product should not be thinned
It is important that the correct coverage is achieved
Safety Precautions
Avoid skin and eye contact i.e. wear gloves, goggles, etc
Ensure good ventilation, mechanical if necessary
Store and use away from heat and flame
Do not eat or smoke in the vicinity of work
Wash hands before eating
Refer to supply container for additional warning labels
IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contactedto obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditionsand should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.
Product Details
EP146
Data sheet
Manufacturer
Tor
Water / Solvent Based
Solvent
Application Method
Brush, roller
Colour
Standard / Ready Mixed
Single, Two or Three Pack
Two-pack
Pack Size
5L
Solvent
Epoxy/polyamide
Mixing Ratio
Base and activator supplied in correct proportions.
Suitable Substrates
Previously painted and non-convertible coatings (eg. pliolite or chlorinated rubber)
Tor Torlife ST Primer is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
Tor Unicover TP Coloured, a 2-pack high performance anti-graffiti, anti-vandal finish coat for the Torlife TP Coloured System, available in over 4,400+ colours from RAL, RAL Design, BS, NCS & the new NCS 2050 colours.For external surfaces on nearly all building types Use in communal areas and industrial environmentsMore...
These surface preparation kits for steel have been created to help provide customers with an easily accessible bundle of tools to aid in the preparation of steel surfaces in accordance with ISO 8501-1 (St2/3) and SSPC (SP 2/3). Please click here for important information about these kits. Kit Contents: SET 1 (Hand Tools)1 x Rust-Oleum...